2
Installation
POWER ON
Turn the power switch on the left side of the copier to the “ON” position. The ready (
) indicator will light up and other indicators which show the initial settings of the operation panel will also light up to indicate the ready condition. For the initial settings, see the “Initial settings of operation panel” described below.
●The copier will enter a power save mode once the set time has elapsed without any copier operation after the last copy of a run is made or power is turned on.
The settings of the power save modes can be modified. See page 27, USER PROGRAMS.
●The copier will return to the initial settings a preset amount of time after the last copy is made.The preset amount of time (auto clear time) can be changed. See page 27, USER PROGRAMS.
Initial settings of operation panel
The copier assumes the initial settings when the copier is turned on or a preset time (auto clear time) elapses after the last copy is made. The initial settings of the operation panel are shown below.
200% | MAX. |
129% | 51/2x81/2 81/2x11 |
100% | 100% |
78% | 81/2x14 81/2x11 |
64% | 81/2x11 51/2x81/2 |
50% | MIN. |
ZOOM
“0” is displayed in the display.
16