Sharp AL-1551 operation manual Transfer charger

Page 35

USER MAINTENANCE

Transfer charger

If copies start becoming streaky or blotchy, the transfer charger may be dirty. Clean the charger using the following procedure.

		1	Turn the power switch off.
		1
			Ensure that the bypass tray is open and then open the side cover while pressing the
		2
		2	side cover open button.
			Take the charger cleaner out by holding the tab.
		3	Take the charger cleaner out by holding the tab.
		3	Set the charger cleaner onto the right end of the transfer charger, gently slide the
			cleaner to the left end, and then remove it. Repeat this operation two or three times.

			Slide the charger cleaner from the right end to the left end along the groove of

			the transfer charger. If the cleaner is stopped on the way, smudges on copies
			may occur.

	4	Return the charger cleaner to its original position. Close the side cover by pressing
	4	the round projections near the side cover open button.
		the round projections near the side cover open button.

5	Turn the power switch on.

5

Supplies and user maintenance

33

Image 35

Contents AL-1551 Or 1-877-SHARP-CC toll free/905-568-7140 in Canada For Your ProtectionContents Appendix Conventions used in this manual Getting StartedIntroduction High-quality digital image Main FeaturesHigh-speed laser copying Environmentally friendly design Printer featureSubstantial copying functions Scan once/ Print manyPart Names Operation Panel Copier Installation InstallationBe sure to allow the required space around Unpacking Checking Packed Components and AccessoriesRemoving Protective Packing Materials Installing the TD Cartridge Loading Copy Paper installing the paper tray Corner hooks Power to Copier Initial settings of operation panel Power onPaper Making CopiesNormal Copying When using the original table When using the RspfWhen copying in the two-sided to one-sided mode When copying in the one-sided to one-sided modeWhen copying in a one-sided to two-sided mode When copying in the two-sided to two-sided modeEnsure that the desired paper tray is selected Stream feeding mode Exposure ADJUSTMENT/PHOTO CopyingREDUCTION/ENLARGEMENT/ZOOM To select a preset copy ratio To select a zoom ratioBypass Feed including special paper Press the tray select Special Functions Toner Save ModePreheat mode Auto power shut-off modeToner Save Mode OFF Displaying Total Number of CopiesTD Cartridge Replacement Supplies and User MaintenanceTD Cartridge Drum Cartridge ReplacementDrum Cartridge Replacement Original table and original cover User MaintenanceCabinet Transfer charger When copier is not in use Misfeed Removal Copier TROUBLE?Misfeed in the paper feed area Misfeed in the fusing areaMisfeed in the transport area Misfeed in the lower paper feed area Misfeed in the Rspf Misfeed Removal Problem Possible cause Solution See TroubleshootingIndication Cause and remedy See Status IndicatorsAutomatic Exposure Adjustment Appendix SpecificationsSpecifications Proper storage Supply Part Numbers and StorageSupply list Moving Instructions TD Cartridge ReplacementNames IndexPacked components Paper Loading Special Page For users in the USA Sharp Electronics Corporation