Sharp AL-1551 operation manual Supplies and User Maintenance, TD Cartridge Replacement

Page 31

5 SUPPLIES AND USER MAINTENANCE

This chapter describes how to replace the TD cartridge and the drum cartridge.

Be sure to use only genuine SHARP parts and supplies.

TD CARTRIDGE REPLACEMENT

The TD cartridge replacement required ( ) indicator will light up when toner is needed. For more information on purchasing the TD cartridge, see SUPPLY PART NUMBERS AND STORAGE on page 46. If copying is continued while theindicator is lit, copies will gradually become lighter until the copier stops and the indicator begins blinking. Replace the old TD cartridge by following the procedure given below.

After the copier stops, it may be possible to make a few more copies by

taking the TD cartridge out of the copier, shaking it horizontally, then reinstalling it. If copying is not possible after this operation, replace the TD cartridge.

During long copy run of a dark original, the ready () indicator may blink, theindicator light up, and the copier stop, even though toner is left. The

copier will feed toner up to 2 minutes and then the ready () indicator will

light up. Press the print () key to restart copying.

1

Ensure that the bypass tray is open and then open the side cover while pressing the

side cover open button.

 

Then, push gently on both sides of the front cover to open the cover.

2

Gently pull the TD cartridge out while pressing the lock release button. Dispose of the

old TD cartridge in accordance with local regulations.

 

 

Lock release button

5

Supplies and user maintenance

29

Image 31
Contents AL-1551 Or 1-877-SHARP-CC toll free/905-568-7140 in Canada For Your ProtectionContents Appendix Introduction Getting StartedConventions used in this manual High-speed laser copying Main FeaturesHigh-quality digital image Environmentally friendly design Printer featureSubstantial copying functions Scan once/ Print manyPart Names Operation Panel Copier Installation InstallationBe sure to allow the required space around Unpacking Checking Packed Components and AccessoriesRemoving Protective Packing Materials Installing the TD Cartridge Loading Copy Paper installing the paper tray Corner hooks Power to Copier Initial settings of operation panel Power onPaper Making CopiesNormal Copying When using the original table When using the RspfWhen copying in the two-sided to one-sided mode When copying in the one-sided to one-sided modeWhen copying in a one-sided to two-sided mode When copying in the two-sided to two-sided modeEnsure that the desired paper tray is selected Stream feeding mode Exposure ADJUSTMENT/PHOTO CopyingREDUCTION/ENLARGEMENT/ZOOM To select a preset copy ratio To select a zoom ratioBypass Feed including special paper Press the tray select Special Functions Toner Save ModePreheat mode Auto power shut-off modeToner Save Mode OFF Displaying Total Number of CopiesTD Cartridge Replacement Supplies and User MaintenanceTD Cartridge Drum Cartridge ReplacementDrum Cartridge Replacement Cabinet User MaintenanceOriginal table and original cover Transfer charger When copier is not in use Misfeed Removal Copier TROUBLE?Misfeed in the paper feed area Misfeed in the fusing areaMisfeed in the transport area Misfeed in the lower paper feed area Misfeed in the Rspf Misfeed Removal Problem Possible cause Solution See TroubleshootingIndication Cause and remedy See Status IndicatorsAutomatic Exposure Adjustment Appendix SpecificationsSpecifications Supply list Supply Part Numbers and StorageProper storage Moving Instructions TD Cartridge ReplacementNames IndexPacked components Paper Loading Special Page For users in the USA Sharp Electronics Corporation