Sharp AL-1551 operation manual Automatic Exposure Adjustment

AUTOMATIC EXPOSURE ADJUSTMENT

The automatic exposure level can be adjusted to suit your copying needs. This level is set for copying from the original table and copying from the RSPF respectively.

1	When adjusting the automatic exposure level for copying from the RSPF, place an
	original in the document feeder tray and make sure that the RSPF ( ) indicator lights
	up.
	When adjusting the level for copying from the original table, make sure that no original
	is left in the document feeder tray.
	Press the exposure mode selector key to select the photo ( ) mode.
2

Press and hold down the exposure mode selector key for approximately 5 seconds.

3 The photo ( ) indicator will go out and the AUTO indicator will begin to blink. One or two exposure indicators corresponding to the automatic exposure level which has been selected will light up.

6

Copier trouble?

4	Press the light ( ) or dark ( ) key to lighten or darken the automatic exposure
	level as desired.
	If exposure level 2 is selected, the two left-handmost indicators for that level will light
	up simultaneously. Also, if level 4 is selected, the two right-handmost indicators for
	that level will light up simultaneously.

5	Press the exposure selector key. The AUTO indicator will stop blinking and light up
	steadily.

This automatic exposure level will remain in effect until you change it again by this procedure.

43