SD CARD FUNCTION
The register’s data can be saved to the SD memory card, and the programming data can be loaded from the SD memory card.
To use the SD card function, turn the mode switch to the Z/PGM position and perform the corresponding operations.
■■ Inserting and removing an SD memory card
The SD card slot is located on the right side of your register.
Inserting an SD memory card
Insert an SD memory card into the SD card slot with the printed SD logo facing upwards. Push the card in steady with a finger until it clicks and release it slowly.
Removing the SD memory card
Push in the card gently with a finger and release it. The card will come out.
NOTE • This model supports SD cards only. Use of any other types of SD cards such as mini SD, micro SD, etc. with an adapter is not supported.
•When inserting or removing the SD memory card, be sure to release it slowly. Otherwise, the card may pop out and injure your finger.
•Never touch or remove the SD memory card while it is accessed, otherwise the data stored in it may be damaged.
•Formatting the SD memory card erases all the data in it.
Caution: Never turn the power off, while the SD memory card is accessed.
■■ SD card formatting
When the SD card is not formatted yet, take the formatting operation.
s 140 @sA
The master folder “SHARP/ECRXXX14” is created for the data file.
74