APC ACRC100, ACRC103 manual Stabilizing the Equipment, Floor brackets, Joining to enclosures

Stabilizing the Equipment

Floor brackets

To prevent the equipment from moving from its final location (if it is not joined with an enclosure), use the included bolt-down kit (AR7701). Follow the installation instructions included with the kit.

Joining to enclosures

NetShelter™ SX enclosure. Two joining brackets are installed on the front and rear of the equipment. Depending on how the holes on the joining brackets are used, you have the option of either 24-in or 600-mm spacing.

1.Remove the front and two rear doors from the equipment. See “Door removal” on page 13.

2.Locate the four joining brackets on the equipment. Rotate each bracket 90° toward the adjoining enclosure so that the bracket is parallel to the floor.

na1573a

3.Install the brackets using the Phillips screws provided with the equipment.

NetShelter VX enclosure. The equipment may be joined to a NetShelter VX enclosure (24-in spacing only) by using an accessory kit (AR7602), sold separately.

InRow RC Installation 15