ADDITIONAL UPS FEATURES
Network Transient Protector
The network transient protector, shown in Figure 38, is located on the rear panel and has jacks labeled IN and OUT. This feature accommodates a single
Low voltage models can also accommodate an
NOTE DO NOT connect any telephone or fax/modem equipment to the 230V models; only network protection is available for 230V models.
1.Connect the input connector of the equipment you are protecting to the jack labeled IN.
2.Connect the network or telephone cable (low voltage models only) to the jack labeled OUT.
IN
OUT
Figure 38. Network Transient Protector
EATON Powerware® 9125 | 49 |
www.powerware.com |
|