SUPER MICRO Computer 6014L-T user manual Floppy Configuration, PCI/PnP Configuration

SUPERSERVER 6014L-T User's Manual

32Bit Data Transfer

Select "Enabled" to activate the 32-bit data transfer function. Select "Disabled" to disable this function. The options are Enabled and Disabled.

Hard Disk Write Protect

Select Enabled to enable the function of Hard Disk Write Protect to prevent data from being written to HDD. The options are Enabled or Disabled.

IDE Detect Time Out

This feature allows the user to set the time-out value for detecting ATA and ATAPI devices installed in the system. The options are 0 (sec), 5, Mode 1.0, 15, 20, 25, 30, and 35.

ATA(PI) 80Pin Cable Detection

This feature allows the AMI BIOS to auto-detect 80-pin ATA(PI) cables. The options are Host & Device, Host and Device.

￿Floppy Configuration

This option allows the user to confi gure the settings for the fl oppy drives installed in the system.

Floppy A

Move the cursor to these fi elds via up and down arrow keys to select the fl oppy type. The options are Disabled, 360 KB 5 1/4", 1.2 MB 5 1/4", 720 KB 3½", 1.44 MB 3½”, and 2.88 MB 3½".

OnBoard Floppy Controller

Select "Enabled" to enable the onboard fl oppy controller. The options are Disabled and Enabled.

￿PCI/PnP Configuration

Plug & Play OS

Select Yes to allow the OS to confi gure Plug & Play devices. (This is not required for system boot if you system has an OS that supports Plug & Play.) Select No to allow the AMI BIOS to confi gure all devices in the system.

PCI Latency Timer

This option sets the latency of all PCI devices on the PCI bus. The default setting is "64." Select "32" to set the PCI latency to 32 PCI clock cycles. Select "64" to set the PCI latency to 64 PCI clock cycles. Select "96" to set the PCI latency to

7-6