SUPER MICRO Computer 6014L-T VGA Enable/Disable, SMBus to PCI Slots, Power Force On, Watch Dog

Chapter 5: Advanced Serverboard Setup

VGA Enable/Disable

JPG1 enables or disables the VGA port on the serverboard. See the table on the right for jumper settings.

VGA Enable/Disable

Jumper Settings (JPG1)

Jumper Setting	Defi nition
Pins 1-2	Enabled
Pins 2-3	Disabled

SMBus to PCI Slots

Jumpers J13 and J15 allow you to con- nect the PCI-X/PCI slots to the System Management Bus. The default setting is open to disable the connection. See the table on the right for jumper settings.

SMBus to PCI

Jumper Settings (J13, J15)

Jumper Setting	Defi nition
Closed	Enabled
Open	Disabled

Power Force On

Jumper JPF allows you to enable or disable the Power Force-On function. If enabled, power will always stay on automatically. If disabled (the default setting), the user must press the power button to power on the system.

Power Force-On

Jumper Settings (JPF)

Jumper Setting	Defi nition
Open	Disabled
Closed	Force Pwr On

Watch Dog

JWD controls Watch Dog, a system monitor that takes action when a soft- ware application freezes the system. Jumping pins 1-2 will cause WD to reset the system if an application is hung up. Jumping pins 2-3 will gen- erate a non-maskable interrupt signal for the application that is hung up. See the table on the right for jumper settings. Watch Dog can also be enabled via BIOS.

Note: When enabled, the user needs to write their own application software to disable the Watch Dog Timer.

Watch Dog

Jumper Settings (JWD)

Jumper Setting	Defi nition
Pins 1-2	Reset
Pins 2-3	NMI
Open	Disabled

5-19