CS4000 Mini Controller with Ethernet
Enclosure Interior | |
Tool Control Module | |
Servo Amplifier | |
Device Control Module | |
Backplane | |
Backplane Fuses | |
Address Switches | |
I/O Board | |
Power Supply | |
Ethernet Interface Card | |
Ground Fault Circuit Interrupter | |
Fuses | |
4. Installing the CS4000 Mini Controller with Ethernet | |
Mounting the CS4000 Mini Controller with Ethernet | |
Power and | |
Meeting the AC Input Power Requirements | |
Grounding | |
I/O Wiring | |
Connector Pinout Definitions | |
Tool Connector | |
I/O Connector | |
Tool Control Module (TCM) Network Connector | |
Printer/Barcode Connector | |
5. Setting Up the Ethernet | |
Programming the Ethernet Interface Card | |
Working with the IP Address, Subnet Mask and Default Gateways | |
Updating Application Settings | |
Setting Up Visual Supervisor for an Ethernet Network | |
Editing VSMain.ini for an Ethernet Network | |
Using Ethernet Network Cables | |
Testing the Ethernet Network | |
Testing Ethernet Network Cables | |
6. Setting Up the 485 Network | |
Installing the SDLC Card | |
Setting Up Visual Supervisor for a 485 Network | |
Editing VSMain.ini for a 485 Network | |
Assigning A Network Address | |
Using 485 Network Cables |
Page viii |