SMC Networks 10/100 manual Configuring Private VLANs

CONFIGURING THE SWITCH

Web – Click VLAN, VLAN Port Configuration or VLAN Trunk Configuration. Fill in the required settings for each interface, click Apply.

CLI – This example sets port 3 to accept only tagged frames, assigns PVID 2 as the native VLAN ID, enables GVRP, sets the GARP timers, and then sets the switchport mode to trunk.

Console(config)#interface ethernet	1/3	3-89
Console(config-if)#switchport acceptable-frame-types tagged		3-126
Console(config-if)#switchport ingress-filtering		3-127
Console(config-if)#switchport native vlan 2		3-128
Console(config-if)#switchport gvrp		3-140
Console(config-if)#garp timer join	30	3-142
Console(config-if)#garp timer leave 90		3-142
Console(config-if)#garp timer leaveall 2000		3-142
Console(config-if)#switchport mode	trunk	3-125
Console(config-if)#

Configuring Private VLANs

Private VLANs provide port-based security and isolation between ports within the assigned VLAN. This switch supports two types of private VLAN ports: promiscuous, and community ports. A promiscuous port can communicate with all interfaces within a private VLAN. Community ports can only communicate with other

2-68