VLAN COMMANDS
Example
The following example shows how to set the interface configuration mode to VLAN 1, and then assign an IP address to the VLAN:
Console(config)#interface vlan 1
Related Commands
shutdown
switchport mode
Use this command to configure the VLAN membership mode for a port. Use the no form to restore the default.
Syntax
switchport mode {trunk access} no switchport mode
•trunk - Specifies a port as an
•access - Sets the port to operate as an untagged interface. All frames are sent untagged.
Default Setting
All ports are in access mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)