SMC Networks 10/100 manual Line Commands

COMMAND LINE INTERFACE

Line Commands

You can access the onboard configuration program by attaching a VT100 compatible device to the server’s serial port. These commands are used to set communication parameters for the serial port or Telnet (i.e., a virtual terminal).

Command	Function	Mode	Page
line	Identifies a specific line for configuration and	GC	3-69
	starts the line configuration mode
login	Enables password checking at login	LC	3-70
password	Specifies a password on a line	LC	3-71
exec-timeout	Sets the interval that the command	LC	3-72
	interpreter waits until user input is detected
password-th	Sets the password intrusion threshold, which	LC	3-73
resh	limits the number of failed logon attempts
silent-time*	Sets the amount of time the management	LC	3-74
	console is inaccessible after the number of
	unsuccessful logon attempts exceeds the
	threshold set by the password-thresh
	command
databits*	Sets the number of data bits per character	LC	3-75
	that are interpreted and generated by
	hardware
parity*	Defines the generation of a parity bit	LC	3-76
speed*	Sets the terminal baud rate	LC	3-77
stopbits*	Sets the number of the stop bits transmitted	LC	3-78
	per byte
show line	Displays a terminal line's parameters	NE,	3-78
		PE

* These commands only apply to the serial port.

3-68