SMC Networks 10/100 manual Address Table Commands, Example

COMMAND LINE INTERFACE

Example

This example sets the rate limit for input and output traffic on port 2 to 312K when operating at 10 Mbps or 3.12 Mbps when operating at 100 Mbps.

Console(config)#

Console(config)#interface ethernet 1/2

Console(config-if)#rate-limit input percent 3

Console(config-if)#rate-limit output percent 3

Console(config)#

Address Table Commands

These commands are used to configure the address table for filtering specified addresses, displaying current entries, clearing the table, or setting the aging time.

Command	Function	Mode	Page
mac-address-table	Maps a static address to a port in a	GC	3-107
static	VLAN
clear	Removes any learned entries from the	PE	3-108
mac-address-table	forwarding database
dynamic
show	Displays entries in the	PE	3-109
mac-address-table	bridge-forwarding database
mac-address-table	Sets the aging time of the address table	GC	3-110
aging-time
show	Shows the aging time for the address	PE	3-111
mac-address-table	table
aging-time

3-106