SMC Networks 10/100 manual System Defaults, Function Parameter Default

SWITCH MANAGEMENT

also provides a facility to upload firmware files to the system directly through the console port. See “Upgrading Firmware via the Serial Port” on page B-1.

Due to the size limit of the flash memory, the switch supports only one operation code file, and two diagnostic code files. However, you can have as many configuration files as available flash memory space allows.

In the system flash memory, one file of each type must be set as the start-up file. During a system boot, the diagnostic and operation code files set as the start-up file are run, and then the start-up configuration file is loaded. Configuration files can also be loaded while the system is running; however, this will automatically reboot the switch.

System Defaults

The switch’s system defaults are provided in the configuration file “Factory_Default_Config.cfg.” To reset the switch defaults, this file should be set as the startup configuration file (page 2-22).

The following table lists some of the basic system defaults.

Function	Parameter	Default
IP Settings	Management VLAN	1
	IP Address	0.0.0.0
	Subnet Mask	255.0.0.0
	Default Gateway	0.0.0.0
	DHCP	Disabled
	BOOTP	Disabled
Web	HTTP Server	Enabled
Management
	HTTP Port Number	80

1-14