SMC Networks 10/100 manual Managing System Files, Enter the name of the start-up file. Press Enter

MANAGING SYSTEM FILES

2. Enter the name of the start-up file. Press <Enter>.

Console#copy running-config startup-config Startup configuration file name []: startup \Write to FLASH Programming.

\Write to FLASH finish. Success.

Console#

Managing System Files

The switch’s flash memory supports three types of system files that can be managed by the CLI program, Web interface, or SNMP. The switch’s file system allows files to be uploaded and downloaded, copied, deleted, and set as a start-up file.

The three types of files are:

•Configuration — This file stores system configuration information and is created when configuration settings are saved. Saved configuration files can be selected as a system start-up file or can be uploaded via TFTP to a server for backup. A file named “Factory_Default_Config.cfg” contains all the system default settings and cannot be deleted from the system. See “Saving or Restoring Configuration Settings” on page 2-22 for more information.

•Operation Code — System software that is executed after boot-up, also known as run-time code. This code runs the switch operation and provides the CLI and Web management interfaces. See “Managing Firmware” on page 2-20 for more information.

•Diagnostic Code — Software that is run during system boot-up, also known as POST (Power On Self-Test). This code

1-13