Western Telematic RPC-4840N manual 2BackPanel

RPC-4840NRemotePowerController;User'sGuide

Figure2.2:BackPanel

￿

￿

￿

￿

￿

￿

￿

2-2

Options Switch: Four DIP Switches which set the default baud rate, boot delay, echo mode, and timeout.

Default Button: Used in conjunction with the Reset Button to reset the unit to defaults (see Section 4.3.)

Console Port: A Male RS-232, DB9 Connector, DTE configuration. For connection to a local PC.

Modem Port: A Male RS-232, DB9 Connector, DTE configuration. For connection to an external modem.

Reset Button: Used in conjunction with the Default Button to reset the unit to defaults (see Section 4.3.)

Circuit Module 1: For connection to your DC power supply and DC powered device. Each circuit is capable of switching up to 40 Amps. Note that power for control functions is also derived from the Circuit 1 input terminal.

A.ON Indicator: Lights when the corresponding Circuit Module is switched On (switch closed).

B.Emergency Override Breaker: If the circuit is overloaded, the breaker pops out and opens the circuit. If necessary the Override Breaker can also be manually pulled out to open the circuit. To reset the circuit, press the Override Breaker in.

Circuit Module 2 (Optional): For connection to a second DC power supply and DC powered device. Same as Circuit Module 1.