Western Telematic RPC-4840N manual Restoring Saved Parameters

Page 40

RPC-4840NRemotePowerController;User'sGuide

7.2. Restoring Saved Parameters

This section describes the procedure for using ProComm to send saved parameters to the RPC-4840N.

1.Start your communications program and access the RPC-4840N command mode using the System Level Password.

2.Configure your communications program to upload an ASCII text file.

3.Upload the file with the saved parameters. If necessary, key in the file name and directory path.

4.When the upload is complete, make certain to terminate the communications program's upload mode.

Note:

The current On/Off status of each RPC-4840N circuit will not be saved or restored. However, the selected default On/Off setting for each circuit will be saved and restored.

When the configuration file is sent to the RPC-4840N via telnet, the unit's IP Address, Subnet Mask, and Gateway Address cannot be altered.

5.Type /SP and press [Enter], the RPC-4840N will display the Status Screen with passwords revealed. Check the Status Screen to make certain that saved parameters have been restored.

7-2

Image 40

Contents WTIPartNo.Rev13224.A Page Nameplate Power Warning Rack Mount InstallationDisconnect Power Ventilation7iii-2 Service CuriyIntelligent Power Control IntroductionFeatures Typographic ConventionsFront Panel Unit DescriptionBack Panel 2BackPanel Quick Start Guide Page QuickStartGuide RPC-4840NRemotePowerControllerUsersGuide Installation Power ConnectionOption Switches Disconnect TimeoutDefault Button / Reset Button Local Reset Unit to DefaultsDefault Parameters Option Connecting the Network Cable Connecting an External ModemConsole Port Connection Configuration System Mode and User ModeCommunicating with the RPC-4840N Ckt Command/Menu Conventions Defining General ParametersOff RPC-4840NRemotePowerControllerUsersGuide Configuration Circuit Parameters4CircuitParametersMenuCircuit1Shown Undefined Network ParametersImplementing IP Security Configuration Save Configuration Parameters Access the Command Mode OperationDisplaying circuit Status Hfor Dischelp mrmaioBoot/On/Off Commands OperationOFF POWER2 or /OF POWER2 and press Enter Default Command Automated ModeRPC-4840NRemotePowerControllerUsersGuide Other Commands Login as Different UserReset Network Port Exit / DisconnectOperating Tips Saving and Restoring Configuration Parameters Sending Parameters to a FileRestoring Saved Parameters Console Port Interface Interface DescriptionsModem Port Interface Specifications Physical / Environmental Operating Temperature 0C to 45CCustomer Service Trademark and Copyright InformationApx-4 Index 10BaseT100BaseT........#.........2-1,4-4SystemPassword

Related manuals

Manual 2 pages 23.95 Kb