Figure5.4:CircuitParametersMenu(Circuit1Shown)
2.Password: (Up to 16 Characters) Assigns a User Password to this circuit. When a User Password is assigned, the circuit is then "owned" by that password. When a User Password is entered at login, the user will have access to only the circuit(s) which are owned by this password. (Default = undefined).
Notes:
If you wish to allow a single user to access both switched circuits, assign the same User Password to both circuits.
If the System Password is defined, and the circuit's User Password is not defined, then the System Password will "own" this circuit, and only the System Mode will be able to control the circuit.
3.Boot Delay: During a Boot cycle, the circuit is first switched off and then switched back on. The Boot Delay is the length of time which elapses between the time when power is switched off and the time that power is restored. The Boot Delay can be 1, 5, 10, 15, 30 or 60 seconds. (Default determined by Option Switch 2; Factory Setting = 5 Seconds).
4.
After Circuit Parameters have been defined, press [Esc] to exit