Western Telematic RPC-4840N manual

RPCConfigurationDisplayReoteCotrolS[P]GHNDmLnmands:[n]-4840NPowerRemoDownloadView/SetExit/DisconnectControllersplaysetCktsNetworkPower.CktthishepcreCktGeral..figuworkv2SttudefaultIntPaController;.0raParamersmeterstionontrface,[P]Site:ttingwithUser'sfileWESTERN+passwords------------------------------------[n]Guide=TELEMATIC,optionalwithaccessCktINC..nameornumber+

BootOTff<n><n><n>BootTurnOReloginffCk.. <n>required*:+n=allCktCkts..throughandCkt..Ckt.n

FigureRPC>/X3.1:TheSystemasdifferHelpScreenuser+------------------------------------+

4.Configure Network Port: In order to communicate with the RPC-4840N via the Network Port, you must first define the IP Address, Subnet Mask, and Gateway Address. At the RPC> command prompt, type /N and press [Enter] to display the Network Parameters menu.

a)Settings for network parameters will depend on the configuration of your individual network. Please contact your network administrator to determine appropriate settings for the IP Address, Subnet Mask, and Gateway Address.

b)To assign network parameters, key in the number for the desired parameter, press [Enter], and then follow the instructions in the resulting submenu. For example, to define the IP Address, type 1 and press [Enter].

3-2