Western Telematic RPC-4840N manual Command/Menu Conventions, Defining General Parameters

Page 22

RPC-4840NRemotePowerController;User'sGuide

5.3. Command/Menu Conventions

When invoking RPC-4840N commands and selecting items from configuration menus, note the following:

￿To display the Help Screen, type /H [Enter].

￿All RPC commands can be invoked at the RPC> command prompt, or from the General Parameters Menu, Port Parameters Menus or Network Parameters Menu.

￿RPC commands are not case sensitive.

￿All commands are invoked by pressing [Enter].

￿To select an item from a menu, key in the number for the item and press [Enter]. To exit from a menu, press [Esc] at any time. Parameters defined up to that point will be saved.

￿The ",Y" option can temporarily suppress the "Sure?" confirmation prompt. The ",Y" option is entered at the end of the command line, immediately following the command or argument. For example, to reset the network port without displaying the "Sure?" prompt, type /T,Y [Enter].

5.4.Defining General Parameters

When the "RPC>" prompt appears, type /G [Enter] to display the General Parameters menu (Figure 5.3). Note that this menu is not available in User Mode. The General Parameters menu offers the following options:

1.System Password: (Up to 16 characters, case-sensitive) When the System Password is defined, the RPC will display a prompt before allowing access to command mode. If the System Password is entered, the RPC will start-up in System Mode. To define the System Password, type 1 and press [Enter]. (Default = undefined).

Note: If the System Password is not defined, the password prompt will not be displayed, and the RPC will always start-up in System Mode.

2.Site ID: Defines a text string (up to 32 characters) that is often used to indicate the installation site. To define the

5-4Site ID, type 2 and press [Enter]. (Default = undefined).

Image 22
Contents WTIPartNo.Rev13224.A Page Nameplate Power Warning Rack Mount InstallationDisconnect Power Ventilation7iii-2 Service CuriyIntelligent Power Control IntroductionFeatures Typographic ConventionsFront Panel Unit DescriptionBack Panel 2BackPanel Quick Start Guide Page QuickStartGuide RPC-4840NRemotePowerControllerUsersGuide Installation Power ConnectionOption Switches Disconnect TimeoutDefault Button / Reset Button Local Reset Unit to DefaultsDefault Parameters Option Connecting the Network Cable Connecting an External ModemConsole Port Connection Configuration System Mode and User ModeCommunicating with the RPC-4840N Ckt Command/Menu Conventions Defining General ParametersOff RPC-4840NRemotePowerControllerUsersGuide Configuration Circuit Parameters4CircuitParametersMenuCircuit1Shown Undefined Network ParametersImplementing IP Security Configuration Save Configuration Parameters Access the Command Mode OperationDisplaying circuit Status Hfor Dischelp mrmaioBoot/On/Off Commands OperationOFF POWER2 or /OF POWER2 and press Enter Default Command Automated ModeRPC-4840NRemotePowerControllerUsersGuide Reset Network Port Other CommandsLogin as Different User Exit / DisconnectOperating Tips Saving and Restoring Configuration Parameters Sending Parameters to a FileRestoring Saved Parameters Console Port Interface Interface DescriptionsModem Port Interface Specifications Physical / Environmental Operating Temperature 0C to 45CCustomer Service Trademark and Copyright InformationApx-4 Index 10BaseT100BaseT........#.........2-1,4-4SystemPassword
Related manuals
Manual 2 pages 23.95 Kb