Western Telematic RPC-4840N manual Other Commands, Login as Different User, Reset Network Port

Page 37

Operation

6.6. Other Commands

6.6.1.Login as Different User

The /R command is used to re-login using a different password. When invoked, the RPC will display the password prompt, allowing the user to enter a different password in order to access the other circuit or System Level command functions. The /R command is typically used to switch from User Mode to System Mode.

The /R command is available in both System Mode and User Mode. To login as a different user, type /R, press [Enter], and then key in a different valid password at the prompt. To suppress the "Sure?" prompt, type /R,Y [Enter].

6.6.2.Reset Network Port

The /T command is used to reinitialize the RPC Network card. The /T command is not available in User Mode. To reset the Network Port, type /T and press [Enter]. To suppress the "Sure?" prompt, type /T,Y [Enter].

Note: The /T command can only be issued via the Console Port or Modem Port. The /T command cannot be invoked via the Network Port.

6.6.3.Exit / Disconnect

To exit from the RPC Command Mode and discontinue connection to the unit, type /X and press [Enter]. The RPC will display the "DISCONNECT" message. To suppress the "Sure?" prompt, type /X,Y [Enter].

Note: Only one port may access the command

 

mode at any given time. In order to allow access to

 

the RPC unit via other ports, always exit from the

 

command mode when you are finished

 

communicating with the unit. For more information,

 

please refer to Section 6.7.

6-7

Page 36 Page 38
Image 37
Page 36 Page 38
Contents WTIPartNo.Rev13224.A Page Rack Mount Installation Nameplate Power WarningVentilation Disconnect Power7iii-2 Curiy ServiceIntroduction Intelligent Power ControlTypographic Conventions FeaturesFront Panel Unit DescriptionBack Panel 2BackPanel Quick Start Guide Page QuickStartGuide RPC-4840NRemotePowerControllerUsersGuide Power Connection InstallationDisconnect Timeout Option SwitchesDefault Button / Reset Button Local Reset Unit to DefaultsDefault Parameters Option Connecting the Network Cable Connecting an External ModemConsole Port Connection System Mode and User Mode ConfigurationCommunicating with the RPC-4840N Ckt Defining General Parameters Command/Menu ConventionsOff RPC-4840NRemotePowerControllerUsersGuide Circuit Parameters Configuration4CircuitParametersMenuCircuit1Shown Network Parameters UndefinedImplementing IP Security Configuration Save Configuration Parameters Operation Access the Command ModeHfor Dischelp mrmaio Displaying circuit StatusOperation Boot/On/Off CommandsOFF POWER2 or /OF POWER2 and press Enter Automated Mode Default CommandRPC-4840NRemotePowerControllerUsersGuide Login as Different User Other CommandsReset Network Port Exit / DisconnectOperating Tips Sending Parameters to a File Saving and Restoring Configuration ParametersRestoring Saved Parameters Console Port Interface Interface DescriptionsModem Port Interface Physical / Environmental Operating Temperature 0C to 45C SpecificationsTrademark and Copyright Information Customer ServiceApx-4 10BaseT100BaseT........#.........2-1,4-4 IndexSystemPassword
Related manuals
Manual 2 pages 23.95 Kb
Top Page Image Contents