Western Telematic manual RPC-4840NRemotePowerControllerUsersGuide

Page 24

RPC-4840NRemotePowerController;User'sGuide

7.Disconnect Timeout: Determines how long the RPC will wait for additional commands. Type 7, press [Enter], and follow the instructions in the submenu. (Default determined by Option Switch 4; Factory Setting = 2 Min.).

Note: It is recommended that the Disconnect Timeout should be set at the lowest acceptable value. Since only one port is allowed to access the command mode at a given time, shorter timeout values will decrease the chance of other users being shut out of command mode if a user fails to disconnect when finished communicating with

the unit.

8.Command Confirmation: When enabled, the RPC will display a "Sure?" prompt before completing the /T, /X, /R, /BOOT, /ON, /OFF, /D and "A" commands, and will also display the System Status screen after commands are successfully completed. When disabled, the "Sure?" prompt is suppressed, and the Status Screen is not sent when commands are completed. (Default = Enabled).

9.Automated Mode: When enabled, the RPC-4840N will execute the /ON, /OFF, /BOOT, /D, and /X commands without displaying the confirmation prompt, status screen, or confirmation messages. This allows the RPC to be controlled by a device that generates commands to control power switching without human interaction. For more information, please refer to Section 6.5.

(Default = Off).

Note: When this option is enabled, password security functions are disabled, and users are able to access System Level menus and control both circuits without entering a password.

5-6

Page 23 Page 25
Image 24
Page 23 Page 25
Contents WTIPartNo.Rev13224.A Page Nameplate Power Warning Rack Mount InstallationDisconnect Power Ventilation7iii-2 Service CuriyIntelligent Power Control IntroductionFeatures Typographic ConventionsUnit Description Front PanelBack Panel 2BackPanel Quick Start Guide Page QuickStartGuide RPC-4840NRemotePowerControllerUsersGuide Installation Power ConnectionOption Switches Disconnect TimeoutReset Unit to Defaults Default Button / Reset Button LocalDefault Parameters Option Connecting an External Modem Connecting the Network CableConsole Port Connection Configuration System Mode and User ModeCommunicating with the RPC-4840N Ckt Command/Menu Conventions Defining General ParametersOff RPC-4840NRemotePowerControllerUsersGuide Configuration Circuit Parameters4CircuitParametersMenuCircuit1Shown Undefined Network ParametersImplementing IP Security Configuration Save Configuration Parameters Access the Command Mode OperationDisplaying circuit Status Hfor Dischelp mrmaioBoot/On/Off Commands OperationOFF POWER2 or /OF POWER2 and press Enter Default Command Automated ModeRPC-4840NRemotePowerControllerUsersGuide Other Commands Login as Different UserReset Network Port Exit / DisconnectOperating Tips Saving and Restoring Configuration Parameters Sending Parameters to a FileRestoring Saved Parameters Interface Descriptions Console Port InterfaceModem Port Interface Specifications Physical / Environmental Operating Temperature 0C to 45CCustomer Service Trademark and Copyright InformationApx-4 Index 10BaseT100BaseT........#.........2-1,4-4SystemPassword
Related manuals
Manual 2 pages 23.95 Kb
Top Page Image Contents