Western Telematic RPC-4840N manual Configuration

Configuration

ExampleSecurity1:MaskDeny#2:1921#1:255access.255.1.to.5255all.255hosts exceptMask#1#2192Action:.1.1.5: DenyPermit

Since 255 is a wild card, Mask #1 blocks all IP Addresses. Mask #2 then specifically grants access to 192.1.1.5 only.

Example 2:MaskAllow#2:192192access255 only by addresses#2that beginPermitwith 192.

SinceSecurity255 is wild#1:25523card,.11. Mask..5255.2551 blocksMask#all IP132addressesAction:PermitDeny. Mask 2 then grants access to all addresses that begin with 192.

Example 3: Allow access only by addresses that begin with 192, deny access to 192. .1.

Since 255 is a wild card, Mask 1 blocks all IP addresses. Mask 2 then grants access to all addresses that begin with 192. Finally, Mask 3 specifically blocks access by 192.1.1.5.

Note:

￿Mask #5 has priority over the other four masks. If Mask #5 is set to deny access by "255.255.255.255" (all wild cards), all IP Addresses will be blocked, and you will not be able to access the RPC-4840N Command Mode via network. Access will only be allowed via the Console Port or Modem Port.

￿When using the wild card address "255.255.255.255" to block access by all IP Addresses, make certain that at least one higher priority mask permits access by your IP address.

5-11