Western Telematic manual RPC-4840NRemotePowerControllerUsersGuide

Page 14

RPC-4840NRemotePowerController;User'sGuide

8.Test Boot Commands: When the RPC-4840N is powered up, both switched circuits will be set in the ON (closed) position. In order to test for proper operation, you may wish to perform the following test. Note that it is not necessary to connect a device to either switched circuit in order to perform this test.

a)Reboot Circuits: To initiate a boot cycle at both circuits, go to the RPC> command prompt, type /BOOT * and press [Enter]. Power to both circuits will be switched OFF. After the Boot Delay Period (Default = 5 Seconds), the power to both circuits will then be automatically switched back ON. Note that the Circuit Status Indicators on the RPC front panel will also switch Off and On.

b)Switch Circuits OFF: To switch both circuits OFF, go to the RPC> command prompt, type /OFF * and then press [Enter]. Power to both circuits will be switched OFF. Note that the Circuit Status Indicators will also be switched Off.

c)Switch Circuits ON: To switch both circuits ON, go to the RPC> command prompt, type /ON * and then press [Enter]. Power to both circuits will be switched ON. Note that the Circuit Status Indicators will also be switched On.

9.Exit Command Mode: Type /X and press [Enter] to exit from the RPC Command Mode, or disconnect using your Telnet program.

This completes the introductory overview of the RPC-4840N. Prior to installing and operating the unit, please review the remainder of this User's Guide for important information regarding safety considerations, as well as more detailed installation, configuration, and operation instructions.

3-4

Page 13 Page 15
Image 14
Page 13 Page 15
Contents WTIPartNo.Rev13224.A Page Nameplate Power Warning Rack Mount InstallationDisconnect Power Ventilation7iii-2 Service CuriyIntelligent Power Control IntroductionFeatures Typographic ConventionsBack Panel Unit DescriptionFront Panel 2BackPanel Quick Start Guide Page QuickStartGuide RPC-4840NRemotePowerControllerUsersGuide Installation Power ConnectionOption Switches Disconnect TimeoutDefault Parameters Option Reset Unit to DefaultsDefault Button / Reset Button Local Console Port Connection Connecting an External ModemConnecting the Network Cable Configuration System Mode and User ModeCommunicating with the RPC-4840N Ckt Command/Menu Conventions Defining General ParametersOff RPC-4840NRemotePowerControllerUsersGuide Configuration Circuit Parameters4CircuitParametersMenuCircuit1Shown Undefined Network ParametersImplementing IP Security Configuration Save Configuration Parameters Access the Command Mode OperationDisplaying circuit Status Hfor Dischelp mrmaioBoot/On/Off Commands OperationOFF POWER2 or /OF POWER2 and press Enter Default Command Automated ModeRPC-4840NRemotePowerControllerUsersGuide Reset Network Port Other CommandsLogin as Different User Exit / DisconnectOperating Tips Saving and Restoring Configuration Parameters Sending Parameters to a FileRestoring Saved Parameters Modem Port Interface Interface DescriptionsConsole Port Interface Specifications Physical / Environmental Operating Temperature 0C to 45CCustomer Service Trademark and Copyright InformationApx-4 Index 10BaseT100BaseT........#.........2-1,4-4SystemPassword
Related manuals
Manual 2 pages 23.95 Kb
Top Page Image Contents