Operation
6.4. The Default Command
The Default Command (/D) sets circuits to their default On/Off status. The default status is set using the Circuit Parameters menus described in Section 5.5. To set the circuits to their default settings, type /D and press [Enter].
Note:
When User Mode is active, this command will only be applied to the circuit owned by the User's password. The command will not be applied to a circuit owned by another User Password.
When the System Mode is active, this command will be applied to both circuits.
This command will always be applied to all owned circuits. It cannot be directed only to a specific circuit module.
6.5.The Automated Mode
The Automated Mode allows the
When the Automated Mode is enabled, the /ON, /OFF, /BOOT, /D and /X commands are executed without a "Sure?" confirmation prompt and without command response messages; the only reply to these commands is the "RPC>" prompt, which is displayed when the command is complete.
Note: When Automated Mode is enabled, all RPC |
|
password security functions are disabled, and users |
|
are able to access System Level command functions |
|
(including the configuration menus), and control |
|
both circuits without entering a password. If you |
|
need to enable the Automated Mode, but want to |
|
restrict network access to RPC configuration menus, |
|
it is recommended to enable and configure the IP |
|
Security Function as described in Section 5.6.1. |