Western Telematic RPC-4840N manual Operation, Boot/On/Off Commands

Page 33

Operation

6.3. Boot/On/Off Commands

These commands are used to Boot or toggle the On/Off status of the RPC-4840N's two switched circuits. If the same password has been applied to both circuits, commands can be directed to Circuit 1, Circuit 2, or both circuits. If a separate User Password has been assigned to each circuit, then commands can only be applied to the circuit that is owned by the User Password entered at log in. Circuits may be specified by name or number.

Notes:

￿When User Mode is active, commands will only be applied to circuits owned by the User's password.

￿To apply a command to both circuits, enter an asterisk (*) in place of the circuit number or name. Commands can only be applied to both circuits when the unit is operating in System Mode, or when both circuits are owned by the same

User Password.

￿When commands are applied to both circuits, the RPC will delay for approximately 1 second between actions. For example, when switching both circuits On, the RPC will switch Circuit 1 On, delay one second, then switch Circuit 2 On.

￿Wait for the "RPC>" prompt to appear before entering commands. The prompt will not reappear until the previous command is complete.

￿Commands are not case sensitive. All commands are invoked by pressing [Enter].

￿If command confirmation is enabled, the RPC will display the Status Screen after the Boot/On/Off commands are successfully completed.

1.Boot Circuit(s): To initiate a Boot cycle, type /BOOT n and press [Enter]. Where "n" is a the number or name of the desired circuit. Note that the "/BOOT" command can also be entered as "/BO".

Examples:

￿To boot both circuits, type /BOOT * or /BO * and then press [Enter].

￿To boot Circuit 1, type /BOOT 1 or /BO 1 and then

press [Enter].

6-3

 

 

Image 33
Contents WTIPartNo.Rev13224.A Page Rack Mount Installation Nameplate Power WarningVentilation Disconnect Power7iii-2 Curiy ServiceIntroduction Intelligent Power ControlTypographic Conventions FeaturesUnit Description Front PanelBack Panel 2BackPanel Quick Start Guide Page QuickStartGuide RPC-4840NRemotePowerControllerUsersGuide Power Connection InstallationDisconnect Timeout Option SwitchesReset Unit to Defaults Default Button / Reset Button LocalDefault Parameters Option Connecting an External Modem Connecting the Network CableConsole Port Connection System Mode and User Mode ConfigurationCommunicating with the RPC-4840N Ckt Defining General Parameters Command/Menu ConventionsOff RPC-4840NRemotePowerControllerUsersGuide Circuit Parameters Configuration4CircuitParametersMenuCircuit1Shown Network Parameters UndefinedImplementing IP Security Configuration Save Configuration Parameters Operation Access the Command ModeHfor Dischelp mrmaio Displaying circuit StatusOperation Boot/On/Off CommandsOFF POWER2 or /OF POWER2 and press Enter Automated Mode Default CommandRPC-4840NRemotePowerControllerUsersGuide Login as Different User Other CommandsReset Network Port Exit / DisconnectOperating Tips Sending Parameters to a File Saving and Restoring Configuration ParametersRestoring Saved Parameters Interface Descriptions Console Port InterfaceModem Port Interface Physical / Environmental Operating Temperature 0C to 45C SpecificationsTrademark and Copyright Information Customer ServiceApx-4 10BaseT100BaseT........#.........2-1,4-4 IndexSystemPassword
Related manuals
Manual 2 pages 23.95 Kb