Omega 308, DAQP-208, 208H user manual

Page 11

2.1.2 Windows 98

1.Insert the DAQP card into any available PC Card socket. The first time a new PC Card type is installed the “Add New Hardware Wizard” window will open. Click Next to continue.

2.The Add New Hardware Wizard provides several options to configure the DAQP card. Select the recommended option radio button: “Search for the best driver for your device”. Click Next to continue.

3.An Install from Disk dialog box will open. Insert the DaqSuite CD, either type in or browse for the correct CD-ROM drive letter and then click OK. Windows 98 will browse the CD until it finds the file ”x:\daqpcard.inf“, where “x” is the CD-ROM drive letter. Click Next to continue.

4.When Windows finishes the configuration process, click Finish to exit the New Hardware Found Wizard.

5.Hardware configuration is not complete until the user has run the desired driver support installation from the DaqSuite CD demo. This support installation is required to install Windows 98 drivers for your DAQP card. Refer to Section 2.3: Data Acquisition Software and Drivers for a list of driver installation options.

2.1.3 Windows 95

1.Insert the DAQP card into any available PC Card socket. The first time a new PC Card type is installed the “New Hardware Found” window will open. Select the “Driver from disk provided by hardware manufacturer” radio button and click OK to continue.

2.An Install from Disk dialog box will open. Insert the DaqSuite CD, either type in or browse for the correct CD-ROM drive letter and then click OK. Windows 95 will browse the CD until it finds the file ”x:\daqpcard.inf“, where “x” is the CD-ROM drive letter and then proceed to configure the hardware.

3.Hardware configuration is not complete until the user has run the desired driver support installation from the DaqSuite CD demo. This support installation is required to install Windows 95 drivers for your DAQP card. Refer to Section 2.3: Data Acquisition Software and Drivers for a list of driver installation options.

DAQP-208/208H/308 Users Manual

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Type II Pcmcia Data Acquisition Adapter s DAQP-208/208H/308WARRANTY/DISCLAIMER Servicing Europe Servicing North AmericaFor immediate technical or application assistance Page Page Table of Contents Page List of Figures and Tables Daqp Series Card Output ConnectorIntroduction Hardware Configuration and Initial Setup Page Software Installation Windows NT Page Data Acquisition Software and Drivers DAQPACL.SYS DAQPAEN.EXE Page Device = C\DAQPACL.SYS Device = C\DAQPACL.SYS b300,i5 Page Page Page Device = C\DAQPAEN.EXE S0,r GND DA0 DA1 Field WiringGND CP-DAQPA Cable AssemblyDaqp Series Card Cable Mapping UIO-37 Terminal Block UIO-37 Screw Terminal BlockTheory of Operation DC/DC Power SupplyProgrammable Gain Control Amplifier Analog Input MultiplexerScan List Register Trigger Circuit A/D Converter and Data Fifo Digital I/O Interrupt and StatusFifo A/D State Machine10 D/A Circuit Timer/CounterPage Pcmcia Interface O RegistersSreset Address Map Bit Page Data Fifo Threshold Setting LSB 1080 Select channel 0, gain 2, 1st entry Page Page Page Page Digital input bit External gain select, high bit All Output Flush scan list command High byte of the almost full threshold 15 2K option 18. D/A Data Port Bit Definition Bits Explanation 15-13 19. D/A Update Modes 20. Timer/Counter Modes Page Page Page Specifications TTL DAQP-208/208H/308 Version April 12
Top Page Image Contents