Section 3 – Installation
NOTE: The recorder is designed to be panel mounted and as such should be considered as permanently connected. Disconnection from the supply must be possible via a customer supplied switch or circuit breaker. This disconnection device must be included in the panel installation and should be clearly marked, in close proximity to the Recorder and easily accessible to the operator.
3.3Installation
The recorder is sized to fit in a standard DIN panel cutout of 5.43” x 5.43” [138 mm x 138 mm] and requires a minimum of 6.5” [188.2 mm] behind panel depth not including power and input source cable space needed. Actual dimensions are shown below.
| Figure |
WARNING: | Do not use this instrument in any manner inconsistent with these operating instructions or |
| under any conditions that exceed the environmental specifications stated. |
Page 14