NetComm NP2500 manual Connecting Network Cable

Page 11

Connecting Network Cable

Ethernet ports. These 24 PoE ports will be automatically activated when a compatible terminal is identified. The Switch will supply power through the PoE port to the connected PD.

For Legacy devices that are not yet compatible, the PoE port will not offer the power to these devices. This feature allows users to freely and safely mix legacy and Power over Ethernet compatible devices on their network.

The Switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and it runs both in half- and full- duplex mode using two pairs of Category 5 cables.

The Switch also supports 2 1000BASE-T Gigabit Ethernet ports; When using the RJ-45 ports, it runs in Auto-negotiation mode and 10Mbps Ethernet or 100Mbps Fast Ethernet that runs both in half and full duplex mode and 1000Mbps Gigabit Ethernet runs in full duplex mode using four pair Category 5.

These RJ-45 ports are Auto-MDI type port. The Switch can auto transform to MDI-II or MDI-X type, so you can just make an easy connection that without worrying if you are using a standard or crossover RJ-45 cable.

Figure 4. Connecting Network Cable

NP2500 24-Port 10/100 PoE + 2-Port 10/100/1000 WebSMART Switch User Guide

11

YML842 Rev1

 

Image 11
Contents Page Contents RJ-45 Network Ports Terms/Usage About this GuidePurpose Gigabit Ethernet Technology IntroductionFast Ethernet Technology Vlan Virtual Local Area Network Switching TechnologyPower over Ethernet PoE Features Unpacking Unpacking and InstallationInstallation Installing the Switch on a Rack Installing the Switch on a DesktopMount the Switch in the rack Connecting Network Cable Connecting Network CableAC Power Front Panel Identifying External ComponentsRear Panel Rear panel of the SwitchFast Ethernet PoE Port Status LEDs Port 1 ~ Understanding LED IndicatorsSystem LEDs Gigabit Ethernet Port Status LEDs Installing the Web Management Utility ConfigurationWeb Management Utility Discovery ListView Trap Monitor ListDelete Item Device SettingConfiguration Setting Add ItemFirmware Upgrade Password ChangeWeb Access Login Configuring the SwitchSetup menu Setup MenuSetup menu Configuring Setup SettingPort Settings QoS Auto, and Disable-for speed or port disable selectionsFlow Control ManagementVlan Group Settings Vlan Settings Virtual Local Area NetworkTrunk Settings Trunk SettingSniffer port Mirror SettingRX receive mode Forward it to the sniffer portSelected port PoE SettingPOE Port Status Current Select to enable or disable the PoE functionPower limit POE System SettingSystem Status Device StatusStatistic StatisticServer System SettingAbnormal* Transmit Error Trap SettingAddress of the manager where the trap is to be sent From where the IP to be loginFunction to change the password Set PasswordBackup Setting Logout Reset SettingGeneral Power over EthernetVcci Warning PerformanceFCC Warning CE Mark WarningYML842 Rev1 Straight and crossover cable configuration RJ-45 Network PortsCross-Over Cabling Straight-Through CablingCustomer Information Contact InformationCopyright Information Product Warranty YML842 Rev1