NetComm NP2500 manual Trap Setting, Address of the manager where the trap is to be sent

Page 35

Trap Setting

Address of the manager where the trap is to be sent.

	Figure 32. Trap Setting
System Events:	Monitoring the system’s trap.
Device Bootup:	a trap when booting up the system.
Illegal Login:	a trap when there is using a wrong password login, and it will record
	from where the IP to be login.
Twisted Pair Port Events:	Monitoring the twisted pair port status.
Abnormal* Receive Error:	a trap when there are receive data error in twisted pair port.
Abnormal* Transmit Error:	a trap when there are transmit data error in twisted pair port.
Abnormal*:	50 error packet count within 10 seconds.
PoE Events:	Monitoring the PoE ports status.
PoE Power fail:	A trap when the port’s power source fails or the PD64012 fails.
Power on/Power off:	A trap when the PoE port’s power is on and down.
Power over current:	A trap when the PoE port’s power is over current.
Power short circuit:	A trap when the PoE port’s power circuit was short.
Power threshold on/off:	A trap when the radio of the system power supply larger than or smaller
	than the System power Threshold setting.

NP2500 24-Port 10/100 PoE + 2-Port 10/100/1000 WebSMART Switch User Guide	35
YML842 Rev1

Image 35

Contents Page Contents RJ-45 Network Ports Terms/Usage About this GuidePurpose Gigabit Ethernet Technology IntroductionFast Ethernet Technology Vlan Virtual Local Area Network Switching TechnologyPower over Ethernet PoE Features Unpacking Unpacking and InstallationInstallation Installing the Switch on a Rack Installing the Switch on a DesktopMount the Switch in the rack Connecting Network Cable Connecting Network CableAC Power Front Panel Identifying External ComponentsRear Panel Rear panel of the SwitchFast Ethernet PoE Port Status LEDs Port 1 ~ Understanding LED IndicatorsSystem LEDs Gigabit Ethernet Port Status LEDs Installing the Web Management Utility ConfigurationWeb Management Utility Discovery ListView Trap Monitor ListDelete Item Device SettingConﬁguration Setting Add ItemFirmware Upgrade Password ChangeWeb Access Login Conﬁguring the SwitchSetup menu Setup MenuSetup menu Conﬁguring Setup SettingPort Settings QoS Auto, and Disable-for speed or port disable selectionsFlow Control ManagementVlan Group Settings Vlan Settings Virtual Local Area NetworkTrunk Settings Trunk SettingSniffer port Mirror SettingRX receive mode Forward it to the sniffer portSelected port PoE SettingPOE Port Status Current Select to enable or disable the PoE functionPower limit POE System SettingSystem Status Device StatusStatistic StatisticServer System SettingAbnormal* Transmit Error Trap SettingAddress of the manager where the trap is to be sent From where the IP to be loginFunction to change the password Set PasswordBackup Setting Logout Reset SettingGeneral Power over EthernetVcci Warning PerformanceFCC Warning CE Mark WarningYML842 Rev1 Straight and crossover cable conﬁguration RJ-45 Network PortsCross-Over Cabling Straight-Through CablingCustomer Information Contact InformationCopyright Information Product Warranty YML842 Rev1