NetComm NP2500 Auto, and Disable-for speed or port disable selections, Flow Control, Management

Page 26

 

This setting has six modes—100M Full, 100M Half, 10M Full, 10M Half,

 

Auto, and Disable—for speed or port disable selections.

Flow Control:

This setting determines whether or not the Switch will be handling flow

 

control. Set FlowCtrl to Enable for avoiding data transfer overflow. If it is

 

set to Disable, there is either no flow control or other hardware/software

 

management.

 

When the 10/100M port is set to full-duplex mode, then the flow control

 

will be automatically set to disable; and if the 10/100M port is set to half-

 

duplex mode, the flow control will be automatically set to enable.

QoS:

In some ports that need to have a high priority to manage the data

 

transfer, QoS should be change, Set the port’s QoS to high to determine

 

the port will always transfer their data first.

26

NP2500 24-Port 10/100 PoE + 2-Port 10/100/1000 WebSMART Switch User Guide

 

YML842 Rev1

Image 26
Contents Page Contents RJ-45 Network Ports Terms/Usage About this GuidePurpose Gigabit Ethernet Technology IntroductionFast Ethernet Technology Vlan Virtual Local Area Network Switching TechnologyPower over Ethernet PoE Features Unpacking Unpacking and InstallationInstallation Installing the Switch on a Desktop Installing the Switch on a RackMount the Switch in the rack Connecting Network Cable Connecting Network CableAC Power Identifying External Components Front PanelRear panel of the Switch Rear PanelFast Ethernet PoE Port Status LEDs Port 1 ~ Understanding LED IndicatorsSystem LEDs Gigabit Ethernet Port Status LEDs Configuration Installing the Web Management UtilityDiscovery List Web Management UtilityMonitor List View TrapAdd Item Device SettingConfiguration Setting Delete ItemPassword Change Firmware UpgradeWeb Access Configuring the Switch LoginSetup Menu Setup menuSetup menu Configuring Setup SettingPort Settings Management Auto, and Disable-for speed or port disable selectionsFlow Control QoSVlan Settings Virtual Local Area Network Vlan Group SettingsTrunk Setting Trunk SettingsForward it to the sniffer port Mirror SettingRX receive mode Sniffer portSelected port PoE SettingPOE Port Status POE System Setting Select to enable or disable the PoE functionPower limit CurrentDevice Status System StatusStatistic StatisticSystem Setting ServerFrom where the IP to be login Trap SettingAddress of the manager where the trap is to be sent Abnormal* Transmit ErrorFunction to change the password Set PasswordBackup Setting Reset Setting LogoutPower over Ethernet GeneralCE Mark Warning PerformanceFCC Warning Vcci WarningYML842 Rev1 RJ-45 Network Ports Straight and crossover cable configurationStraight-Through Cabling Cross-Over CablingCustomer Information Contact InformationCopyright Information Product Warranty YML842 Rev1