NetComm NP2500 manual Installing the Switch on a Desktop, Installing the Switch on a Rack

Page 9

Installing the Switch on a Desktop

attached. Attach these cushioning feet on the bottom at each corner of the device. Allow enough ventilation space between the Switch and any other objects in the vicinity.

Figure 1. Installed on a Desktop

Installing the Switch on a Rack

The Switch can be mounted in an EIA standard-size, 19-inch rack, which can be placed in a wiring closet with other equipment. Attach the mounting brackets at the Switch’s front panel (one on each side), and secure them with the provided screws.

Figure 2. Combine the Switch with the provided screws.

Then, use screws provided with the equipment rack to mount each switch in the rack.

NP2500 24-Port 10/100 PoE + 2-Port 10/100/1000 WebSMART Switch User Guide	9
YML842 Rev1

Image 9

Contents Page Contents RJ-45 Network Ports About this Guide PurposeTerms/Usage Introduction Fast Ethernet TechnologyGigabit Ethernet Technology Switching Technology Power over Ethernet PoEVlan Virtual Local Area Network Features Unpacking and Installation InstallationUnpacking Installing the Switch on a Rack Installing the Switch on a DesktopMount the Switch in the rack Connecting Network Cable Connecting Network CableAC Power Front Panel Identifying External ComponentsRear Panel Rear panel of the SwitchUnderstanding LED Indicators System LEDsFast Ethernet PoE Port Status LEDs Port 1 ~ Gigabit Ethernet Port Status LEDs Installing the Web Management Utility ConfigurationWeb Management Utility Discovery ListView Trap Monitor ListConﬁguration Setting Device SettingAdd Item Delete ItemFirmware Upgrade Password ChangeWeb Access Login Conﬁguring the SwitchSetup menu Setup MenuConﬁguring Setup Setting Port SettingsSetup menu Flow Control Auto, and Disable-for speed or port disable selectionsManagement QoSVlan Group Settings Vlan Settings Virtual Local Area NetworkTrunk Settings Trunk SettingRX receive mode Mirror SettingForward it to the sniffer port Sniffer portPoE Setting POE Port StatusSelected port Power limit Select to enable or disable the PoE functionPOE System Setting CurrentSystem Status Device StatusStatistic StatisticServer System SettingAddress of the manager where the trap is to be sent Trap SettingFrom where the IP to be login Abnormal* Transmit ErrorSet Password Backup SettingFunction to change the password Logout Reset SettingGeneral Power over EthernetFCC Warning PerformanceCE Mark Warning Vcci WarningYML842 Rev1 Straight and crossover cable conﬁguration RJ-45 Network PortsCross-Over Cabling Straight-Through CablingContact Information Copyright InformationCustomer Information Product Warranty YML842 Rev1