NetComm NP2500 manual Add Item, Delete Item, Device Setting, Conﬁguration Setting

Page 20

Figure 10. Trap information

Trap Events in the Web browser. These settings are available in the Trap Setting Menu.

Add Item

To add a device to the Monitor List manually, enter the IP Address of the device that you want to monitor.

Delete Item

To delete the device in the Monitor List.

Device Setting

You can set the device by using the function key in the Device Setting Dialog box.

Conﬁguration Setting

You can set the device by using the function key in the Device Setting Dialog box.

Conﬁguration Setting: In this Conﬁguration Setting, you can set the IP Address, Subnet Mask, Gateway, Set Trap to (Trap IP Address), System name and Location.

Select the device in the Discovery list or Monitor List and press this button, then the Conﬁguration Setting window will pop out as Figure 11, after ﬁlling up the data that you want to change, you must ﬁll up the password and press the “Set” to process the data changed immediately. The default password of this 24-Port 10/100/1000Mbps Gigabit Ethernet Web Smart Switch conﬁguration is “admin”.

Figure 11. Conﬁguration Setting

20	NP2500 24-Port 10/100 PoE + 2-Port 10/100/1000 WebSMART Switch User Guide
	YML842 Rev1

Image 20

Contents Page Contents RJ-45 Network Ports Terms/Usage About this GuidePurpose Gigabit Ethernet Technology IntroductionFast Ethernet Technology Vlan Virtual Local Area Network Switching TechnologyPower over Ethernet PoE Features Unpacking Unpacking and InstallationInstallation Installing the Switch on a Desktop Installing the Switch on a RackMount the Switch in the rack Connecting Network Cable Connecting Network CableAC Power Identifying External Components Front PanelRear panel of the Switch Rear PanelFast Ethernet PoE Port Status LEDs Port 1 ~ Understanding LED IndicatorsSystem LEDs Gigabit Ethernet Port Status LEDs Configuration Installing the Web Management UtilityDiscovery List Web Management UtilityMonitor List View TrapDevice Setting Conﬁguration SettingAdd Item Delete ItemPassword Change Firmware UpgradeWeb Access Conﬁguring the Switch LoginSetup Menu Setup menuSetup menu Conﬁguring Setup SettingPort Settings Auto, and Disable-for speed or port disable selections Flow ControlManagement QoSVlan Settings Virtual Local Area Network Vlan Group SettingsTrunk Setting Trunk SettingsMirror Setting RX receive modeForward it to the sniffer port Sniffer portSelected port PoE SettingPOE Port Status Select to enable or disable the PoE function Power limitPOE System Setting CurrentDevice Status System StatusStatistic StatisticSystem Setting ServerTrap Setting Address of the manager where the trap is to be sentFrom where the IP to be login Abnormal* Transmit ErrorFunction to change the password Set PasswordBackup Setting Reset Setting LogoutPower over Ethernet GeneralPerformance FCC WarningCE Mark Warning Vcci WarningYML842 Rev1 RJ-45 Network Ports Straight and crossover cable conﬁgurationStraight-Through Cabling Cross-Over CablingCustomer Information Contact InformationCopyright Information Product Warranty YML842 Rev1