NetComm NP2500 manual PoE Setting, POE Port Status, Selected port

Page 30

PoE Setting

including, Port Enable, Power limit, Power (W), Voltage(V), Current (mA), Classiﬁcation, Port status, System Budget Power, Support Total Power, Remainder Power and The ratio of system power supply.

Note:	The PoE Status information of Power current, Power Voltage and Current are exist power
	usage information of connected PD, please “Refresh” to renew information.

	Figure 25. PoE Status
POE Port Status:	Selected “POE Port Status” to conﬁgure the PoE Port setting.
	To conﬁgure the settings, press click on the ID parameter to enter to the
	selected port.

30	NP2500 24-Port 10/100 PoE + 2-Port 10/100/1000 WebSMART Switch User Guide
	YML842 Rev1

Image 30

Contents Page Contents RJ-45 Network Ports About this Guide PurposeTerms/Usage Introduction Fast Ethernet TechnologyGigabit Ethernet Technology Switching Technology Power over Ethernet PoEVlan Virtual Local Area Network Features Unpacking and Installation InstallationUnpacking Installing the Switch on a Desktop Installing the Switch on a RackMount the Switch in the rack Connecting Network Cable Connecting Network CableAC Power Identifying External Components Front PanelRear panel of the Switch Rear PanelUnderstanding LED Indicators System LEDsFast Ethernet PoE Port Status LEDs Port 1 ~ Gigabit Ethernet Port Status LEDs Configuration Installing the Web Management UtilityDiscovery List Web Management UtilityMonitor List View TrapAdd Item Device SettingConﬁguration Setting Delete ItemPassword Change Firmware UpgradeWeb Access Conﬁguring the Switch LoginSetup Menu Setup menuConﬁguring Setup Setting Port SettingsSetup menu Management Auto, and Disable-for speed or port disable selectionsFlow Control QoSVlan Settings Virtual Local Area Network Vlan Group SettingsTrunk Setting Trunk SettingsForward it to the sniffer port Mirror SettingRX receive mode Sniffer portPoE Setting POE Port StatusSelected port POE System Setting Select to enable or disable the PoE functionPower limit CurrentDevice Status System StatusStatistic StatisticSystem Setting ServerFrom where the IP to be login Trap SettingAddress of the manager where the trap is to be sent Abnormal* Transmit ErrorSet Password Backup SettingFunction to change the password Reset Setting LogoutPower over Ethernet GeneralCE Mark Warning PerformanceFCC Warning Vcci WarningYML842 Rev1 RJ-45 Network Ports Straight and crossover cable conﬁgurationStraight-Through Cabling Cross-Over CablingContact Information Copyright InformationCustomer Information Product Warranty YML842 Rev1