NetComm NP2500 manual Set Password, Backup Setting, Function to change the password

Page 36

Set Password

function to change the password.

If you forget the password, press the “Reset” button in the rear panel of the Switch. The current setting includes VLAN, Port Setting… etc. will be lost and the Switch will be restored to the default setting.

Figure 33.Set Password

Backup Setting

The backup tools help you to backup the current setting of the Switch. Once you need to backup the setting, press the “Backup” button to save the setting.

To restore a current setting ﬁle to the device, you must specify the backup ﬁle and press the “Restore” button to process the setting of the recorded ﬁle.

Figure 34. Backup Setting

Note: When restoring a recorded ﬁle, the current password will not be erased.

36	NP2500 24-Port 10/100 PoE + 2-Port 10/100/1000 WebSMART Switch User Guide
	YML842 Rev1

Image 36

Contents Page Contents RJ-45 Network Ports About this Guide PurposeTerms/Usage Introduction Fast Ethernet TechnologyGigabit Ethernet Technology Switching Technology Power over Ethernet PoEVlan Virtual Local Area Network Features Unpacking and Installation InstallationUnpacking Installing the Switch on a Desktop Installing the Switch on a RackMount the Switch in the rack Connecting Network Cable Connecting Network CableAC Power Identifying External Components Front PanelRear panel of the Switch Rear PanelUnderstanding LED Indicators System LEDsFast Ethernet PoE Port Status LEDs Port 1 ~ Gigabit Ethernet Port Status LEDs Configuration Installing the Web Management UtilityDiscovery List Web Management UtilityMonitor List View TrapDevice Setting Conﬁguration SettingAdd Item Delete ItemPassword Change Firmware UpgradeWeb Access Conﬁguring the Switch LoginSetup Menu Setup menuConﬁguring Setup Setting Port SettingsSetup menu Auto, and Disable-for speed or port disable selections Flow ControlManagement QoSVlan Settings Virtual Local Area Network Vlan Group SettingsTrunk Setting Trunk SettingsMirror Setting RX receive modeForward it to the sniffer port Sniffer portPoE Setting POE Port StatusSelected port Select to enable or disable the PoE function Power limitPOE System Setting CurrentDevice Status System StatusStatistic StatisticSystem Setting ServerTrap Setting Address of the manager where the trap is to be sentFrom where the IP to be login Abnormal* Transmit ErrorSet Password Backup SettingFunction to change the password Reset Setting LogoutPower over Ethernet GeneralPerformance FCC WarningCE Mark Warning Vcci WarningYML842 Rev1 RJ-45 Network Ports Straight and crossover cable conﬁgurationStraight-Through Cabling Cross-Over CablingContact Information Copyright InformationCustomer Information Product Warranty YML842 Rev1