NetComm NP2500 manual Conﬁguring the Switch, Login

Page 23

Conﬁguring the Switch

Web Browser. A network administrator can manage, control, and monitor the Switch from the local LAN. This section indicates how to conﬁgure the Switch to enable its smart functions including: Port Setting, VLAN Set- ting, Trunking Setting, Port Mirroring, PoE Setting, Status, Statistics, System Setting, Trap Setting, Password Setting, Backup Setting, Reset Setting.

Login

Before you conﬁgure this device, note that when the Web Smart Switch is conﬁgured through an Ethernet connection, make sure the manager PC must be set on same the IP network. For example, when the default IP address of the Web Smart Switch is 192.168.0.1, then the manager PC should be set at 192.168.0.x (where x is a number between 2 and 254), and the default subnet mask is 255.255.255.0.

Open the web browser program and Enter IP address http://192.168.0.1 (the factory-default IP address setting) to the address location.

Figure 14.

Or through the Web Management Utility, you do not need to remember the IP Address, select the device shown in the Monitor List of the Web Management Utility to settle the device on the Web Browser.

When the following dialog page appears, remain enter the default password “admin” and press Login to enter the main conﬁguration window.

Figure 15

After entering the password, the main page appears, and the screen will display the device status.

NP2500 24-Port 10/100 PoE + 2-Port 10/100/1000 WebSMART Switch User Guide	23
YML842 Rev1

Image 23

Contents Page Contents RJ-45 Network Ports Terms/Usage About this GuidePurpose Gigabit Ethernet Technology IntroductionFast Ethernet Technology Vlan Virtual Local Area Network Switching TechnologyPower over Ethernet PoE Features Unpacking Unpacking and InstallationInstallation Installing the Switch on a Rack Installing the Switch on a DesktopMount the Switch in the rack Connecting Network Cable Connecting Network CableAC Power Front Panel Identifying External ComponentsRear Panel Rear panel of the SwitchFast Ethernet PoE Port Status LEDs Port 1 ~ Understanding LED IndicatorsSystem LEDs Gigabit Ethernet Port Status LEDs Installing the Web Management Utility ConfigurationWeb Management Utility Discovery ListView Trap Monitor ListDelete Item Device SettingConﬁguration Setting Add ItemFirmware Upgrade Password ChangeWeb Access Login Conﬁguring the SwitchSetup menu Setup MenuSetup menu Conﬁguring Setup SettingPort Settings QoS Auto, and Disable-for speed or port disable selectionsFlow Control ManagementVlan Group Settings Vlan Settings Virtual Local Area NetworkTrunk Settings Trunk SettingSniffer port Mirror SettingRX receive mode Forward it to the sniffer portSelected port PoE SettingPOE Port Status Current Select to enable or disable the PoE functionPower limit POE System SettingSystem Status Device StatusStatistic StatisticServer System SettingAbnormal* Transmit Error Trap SettingAddress of the manager where the trap is to be sent From where the IP to be loginFunction to change the password Set PasswordBackup Setting Logout Reset SettingGeneral Power over EthernetVcci Warning PerformanceFCC Warning CE Mark WarningYML842 Rev1 Straight and crossover cable conﬁguration RJ-45 Network PortsCross-Over Cabling Straight-Through CablingCustomer Information Contact InformationCopyright Information Product Warranty YML842 Rev1