NetComm NP2500 manual Monitor List, View Trap

Page 19

Monitor List

status of the devices.

System word definitions in the Monitor List:

S: Shows the system symbol of the Web-Smart device, represents a device system that is not alive.

IP Address: Shows the current IP address of the device.

MAC Address: Shows the device MAC Address.

Protocol version: Shows the version of the Utility protocol.

Product Name: Shows the device product name.

System Name: Shows the appointed device system name.

Location: Shows where the device is located.

Trap IP: Shows the IP where the Trap is to be sent.

Subnet Mask: Shows the Subnet Mask set of the device.

Gateway: Shows the Gateway set of the device.

View Trap

The Trap function can receive the events that happen on the Web Management Switch in the Monitor List.

There is a light indicator behind the “View Trap” button. When the light is green, it means that there is no trap transmitted, and when it is red, it means that a new trap has been transmitted, reminding us to view the trap. (Figure 9)

Figure 9. View trap button

When the “View Trap” button is clicked, a Trap Information window will pop up. It will display the trap informa- tion including the Symbol, Time, Device IP, and the Event occurred. (Figure 10)

The symbol “” represents the trap signal, this symbol will disappear after you review and click on the event record.

NP2500 24-Port 10/100 PoE + 2-Port 10/100/1000 WebSMART Switch User Guide

19

YML842 Rev1

 

Image 19
Contents Page Contents RJ-45 Network Ports Purpose About this GuideTerms/Usage Fast Ethernet Technology IntroductionGigabit Ethernet Technology Power over Ethernet PoE Switching TechnologyVlan Virtual Local Area Network Features Installation Unpacking and InstallationUnpacking Installing the Switch on a Rack Installing the Switch on a DesktopMount the Switch in the rack Connecting Network Cable Connecting Network CableAC Power Front Panel Identifying External ComponentsRear Panel Rear panel of the SwitchSystem LEDs Understanding LED IndicatorsFast Ethernet PoE Port Status LEDs Port 1 ~ Gigabit Ethernet Port Status LEDs Installing the Web Management Utility ConfigurationWeb Management Utility Discovery ListView Trap Monitor ListDelete Item Device SettingConfiguration Setting Add ItemFirmware Upgrade Password ChangeWeb Access Login Configuring the SwitchSetup menu Setup MenuPort Settings Configuring Setup SettingSetup menu QoS Auto, and Disable-for speed or port disable selectionsFlow Control ManagementVlan Group Settings Vlan Settings Virtual Local Area NetworkTrunk Settings Trunk SettingSniffer port Mirror SettingRX receive mode Forward it to the sniffer portPOE Port Status PoE SettingSelected port Current Select to enable or disable the PoE functionPower limit POE System SettingSystem Status Device StatusStatistic StatisticServer System SettingAbnormal* Transmit Error Trap SettingAddress of the manager where the trap is to be sent From where the IP to be loginBackup Setting Set PasswordFunction to change the password Logout Reset SettingGeneral Power over EthernetVcci Warning PerformanceFCC Warning CE Mark WarningYML842 Rev1 Straight and crossover cable configuration RJ-45 Network PortsCross-Over Cabling Straight-Through CablingCopyright Information Contact InformationCustomer Information Product Warranty YML842 Rev1