Multi-Tech Systems MT5634ZBA-DID Cisco Configuration, Command Speed Response, $Dn DTR Dialing

MultiModemDID User Guide		Chapter 4 - AT Commands, S-Registers, Result Codes
Command:	%Rn	Cisco Configuration
Values:		n = 0, 1
Default:		0
Description:	%R0	Disables Cisco configuration.
	%R1	Sets E0, Q1, &D0, \N0, $SB9600, and %S1 for operation with
		a Cisco router.
Command:	%Sn	Command Speed Response
Values:		n = 0, 1
Default:		0
Description:	%S0	Sets modem to respond to AT commands at all normal speeds.
	%S1	AT commands accepted at 115200 bps only. AT commands at
		other speeds are ignored.
Command:	$Dn	DTR Dialing
Values:		n = 0 or 1
Default:		0
Description:	$D0	Disables DTR dialing.
	$D1	Dials the number in memory location 0 when DTR goes high.
Command:	$EBn	Asynchronous Word Length
Values:		n = 0 or 1
Default:		0
Description:	$EB0	Enables 10-bit mode.
	$EB1 Enables 11-bit mode.
Command:	$SBn	Serial Port Baud Rate
Values:		n = speed in bits per second
Default:		57600
Description: $SB300		Set serial port to 300 bps.
	$SB1200 Set serial port to 1200 bps.
	$SB2400 Set serial port to 2400 bps.
	$SB4800 Set serial port to 4800 bps.
	$SB9600 Set serial port to 9600 bps.
	$SB19200 Set serial port to 19200 bps.
	$SB38400 Set serial port to 38400 bps.
	$SB57600 Set serial port to 57600 bps.
	$SB115200 Set serial port to 115200 bps.
Command: +DCS=x,y Select V.44 Data Compression
Values:		x = 0 or 1 (V.42bis)
		y = 0, 1, or 2 (V.44)
Default:		1, 2
Description:		Selects V.42bis/V.44 data compression.
+DCS=0,0		V.42bis and V.44 data compression are both disabled.
+DCS=0,1		V.42bis is disabled; V.44 data compression is acceptable.
+DCS=0,2		V.42bis is disabled; V.44 only when connected to a V.92
		server.
+DCS=1,0		V.42bis is acceptable; V.44 data compression is disabled.
+DCS=1,1		V.42bis is acceptable; V.44 data compression is acceptable.
+DCS=1,2		V.42bis is acceptable; V.44 only when connected to a V.92 server.
+DCS=?		Displays the allowed values.
+DCS?		Displays the current value.

23