GarrettCom Magnum 700X manual Connecting Twisted Pair RJ-45, Unshielded or Shielded

Page 27

Magnum 700X Mini-Concentrators	Installation and User Guide (05/98)

3.2.7Connecting Twisted Pair (RJ-45, Unshielded or Shielded)

The following procedure describes how to connect a 10BASE-T twisted pair segment to the RJ-45 port on the RPM-TP or BPM-TP. The procedure is the same for both unshielded and shielded twisted pair segments.

1.Using standard 10BASE-T media, insert either end of the cable with an RJ-45 plug into the RJ-45 connector of the PM-TP. Note that, even though the PM-TP connector is shielded, either unshielded or shielded 10BASE-T cables and wiring may be used.

2.Connect the other end of the cable to the corresponding device.

The Magnum PM-TP is equipped with a cross-over slide switch to accommodate repeater-to-repeater connections without special cross-over connectors.

Set the slide switch to the "down" position for normal twisted pair cable segments from the PM- TP to a user device. Set the slide switch to the "up" position for cascaded or up-link segment connections to another repeater or hub in the network.

To help recall the right slide switch position, remember "up for up-link" !

3.3Removing the PM Face Plate

The Magnum 700X is normally received from the factory configured with all required PM modules installed. There may be situations where additional PM cards need to be added or, in some cases, replaced. In cases where additional PM cards are needed, the face plate for an available slot must be removed. The following procedure describes this operation.

1.Removing Chassis Cover

STOP!!!

Be sure the power cord is unplugged

from the chassis before attempting to remove

and/or replace an PM card.

Failure to do so may result in damage to the unit

and will void the warranty.

GARRETT

22

Image 27

Contents Magnum 700X Mini-Concentrator Trademarks Magnum Mini-Concentrator Installation and User GuideContacting Garrett Communications Phone 510Introduction Table of ContentsMagnum  Specifications Packaging Technical Specifications, ConnectorsLED Indicators on Chassis WarrantySpecifications Bridge Port Modules BPMs Specifications Repeater Port Modules RPMsOrdering Information Magnum 700X Mini-Concentrator Introduction Inspecting the Package and ProductProduct Description 1 Magnum 700X Mini-Concentrator Magnum 700X ChassisMagnum 700X Repeater Port Modules RPMs RPM-DTE, RPM-FST, RPM-FSC, RPM-TP, & PM-FPRPM-BNC RPM-AUI Magnum RPM-BNCPin Function 2 AUI Pin AssignmentsRPM-FST Fiber ST, Twist-lock Connector RPM-DTEMagnum RPM-FST 3 km RPM-FSC Fiber SC, Snap-in ConnectorConnector Magnum RPM-FSC RPM-SMF Single-mode Fiber Jumper Across Distances Supported10 km Not usedPM-FP Proper cooling air flow, and for safety Magnum PM-FPRPM-TP Twisted Pair Magnum RPM-TPPage BPM-AUI BPM-FSTMagnum BPM-FST Transceiver functionality. The Link Wiring STP of 150m 500 ft.. ThisBPM-TP Module is designed with internalOptional Bridge Port Modules BPMs Front Mounted Connectors and LEDsInternal Universal Power Supply with Auto-ranging RPMs Repeater Port Modules for All Standard Ethernet MediaIeee Standard Reference Max. Distance Taps PM Type ApplicationsLocating Magnum 700X Mini-Concentrators InstallationConnecting Ethernet Media Media Ieee Standard Connector PM typeConnecting ThinNet 10BASE2 BNC Connecting ThickNet 10BASE5 AUIConnecting Drop Cable 10BASE5 DTE Connecting Single-Mode Fiber Optic SMF Connecting Fiber Optic SC-type, Snap-inRemoving the PM Face Plate Connecting Twisted Pair RJ-45, Unshielded or ShieldedPower Supply Align the connector Pins on the PM card Installing PM CardsInstalling the PM Card Connector socket slotRemoving PM Cards Operation Repeater FunctionalityBPM Local Bridge Functionality Written there. This happens when a Cases where an internal packet is filteredWhen the packet’s source is external, it 2c and 4.2d respectively. When an2d External Packet Filtered 12.2e Local Isolation with Bridge Port Module Powering the Magnum 700X Mini-ConcentratorChassis LEDs Magnum 700X chassis unit LEDsPM LEDs Before Calling for Assistance TroubleshootingReturn Material Authorization RMA Procedure When Calling for AssistanceShipping and Packaging Information No Problem FoundAppendix a Warranty Information