Magnum 700X | Installation and User Guide (05/98) |
|
|
2.Remove PM Retaining Screws
On the front of the unit there are two retaining screws for each PM card slot. These screws are used to secure the face plate in position. These screws are also used to secure individual PM modules. (See Figure 3.3c).
Magnum 700X
Magnum 700X Chassis
PM
Retaining
Screws
Chassis
Base
Figure 3.3c: Front Panel View - PM Retaining Screws
Once the face plate or PM has been removed, proceed to Section 3.4 and install the PM
card.
3.4Installing PM Cards
Up to seven assorted PM (Port Module) cards are easily installed in the Magnum 700X
1.Removing 700X Chassis Cover and PM Retaining Screws
Follow the procedure described for Face Plates in Section 3.3, Steps 1 and 2, above.
|
| RPM Retaining |
|
|
| Screw Hole |
|
2. | Installing the PM Card | - PM Media Interface | PM Mounting |
|
| Plate | |
| Each PM card fits | - ST (Fiber) |
|
| - SMA (Fiber) |
| |
|
| - BNC (ThinNet) |
|
| easily into any available | - AUI (ThickNet) |
|
| - | Magnum | |
|
| - DTE | PM Card |
| connector socket slot. | - SMF (Fiber) | |
|
| ||
|
|
| |
| Align the connector |
|
|
| pins on the PM card | PM | Eight (8) Pin |
| PM Conector | ||
|
| Retaining |
|
| with the connector | Screw Hole |
|
|
|
| |
| socket inside the unit. | Side View of PM Card |
|
GARRETT 
24