GarrettCom Magnum 6K32T user manual 1 RS-232 DB-9 Console Com port Serial port pin assignments

Page 43

Magnum 6K32 & 6K32T Managed Switch

Installation and User Guide (12/05)

Note: For detail description of Managed Network Software (MNS-6K) and Magnum 6K32T Switch configuration for Network Management, please refer to Magnum 6K32T Software Manual available on GarrettCom‘s FTP site. Detail info. about the MNS is available on 2.2.9 ( see page no. 13) of this manual.

3.6.1RS-232 (DB-9) Console Com port (Serial port) pin assignments.

Pin 1

Pin 5

DB-9 (Console port connector)

Pin

Signal

Description

 

 

 

1

CD

Carrier detect (not used)

2

RXD

Receive Data (input)

3

TXD

Transmit Data (output)

4

open

not used

5

GND

Signal Ground

6-9

open

not used

The above provided information enables a managed station( a PC or Console terminal) to connect directly to the switch using a straight through cable.

Note: For using Console port to configure the managed switch, a serial (Null-modem) female to female cable is required to communicate properly. The Null-Modem (DB-9) cable is optional and can be order from the factory, along with the unit as- CONSOLE CBL for serial port

CONSOLE USB for USB port

4.0OPERATION

This chapter describes the functions and operation of the Magnum 6K32T Switch.

4.1Switching Functionality

A Magnum 6K32T provides switched connectivity at Ethernet wire-speed

among all of its ports. The Magnum 6K32T supports10/100Mbs for copper media and 10 or 100Mb separate traffic domains for fiber ports to maximize bandwidth utilization and network performance. All ports can communicate to all other ports in a Magnum

www . GarrettCom . com

37

Page 42 Page 44
Image 43
Page 42 Page 44
Contents Managed Switch Trademarks Canadian Emission Contacting GarrettCom, IncIntroduction Table of ContentsMagnum 6K32T Managed Switch Port Modules Personal Hubs, 10Mb series Personal Switches, 10/100MbTechnical Specifications LEDs Per Port Fiber connector types supportedManagement Console connector Power Supply InternalPer-port MDI or Mdix on RJ-45 Relay Alarm Contact OptionalAgency Approvals Gigabit Transceiver options Configuration OptionsOrdering Information Magnum 6K32T Port ModulesWww . GarrettCom . com Introduction Inspecting the Package and Product Product Description Magnum 6K32T Managed Switch 1a Magnum 6K32T Chassis 1b New Magnum 6K32T Chassis Eight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb fiber Mode for best fiber distance100Mb fiber eight Port modules for the Magnum Eight-Port Copper Module, 6K8-RJ45 @RJ-45 + 2@ 100Mb Four-Port 10 Mb mm Fiber ST ModulesST or SC Gigabit 1000Mbps port modules Frame Buffering and Flow Control Packet Prioritization, 802.1p QOSMIBs for Snmp visit Managed Network Software MNS-6K for Magnum 6K32T„ Managed switching for high performance Ethernet LANs Features and Benefits„ Features Fiber-Built-In Applications Example 1 Magnum 6K32T Switch for a Vlan applicationData Example 3 Redundant Application Www . GarrettCom . com Www . GarrettCom . com Locating Magnum 6K32T Switches InstallationCopper Connecting Ethernet MediaConnecting Fiber Optic ST-type, twist-lock Ieee Standard Media Type Max. Distance Port Module FiberConnecting Single-Mode Fiber Optic Connecting Fiber Optic SC-type, Snap-InMedia Ieee Standard Twisted Pair CAT-5e 1000BASE-T F10ST Rack-mounting for 19 Retma racks, Magnum 6K32T’s Table-Top or Shelf MountingMagnum 6K32T unit. These 1 Dual Side-Mountings for Magnum 6K32T units Rack-mounting, Reverse version of the Magnum 6K32T’sPowering the Magnum 6K32T Managed Switch Preparation for Installing and Removing 6KPMs 6K32T Port Module 6KPM InstallationRemove Chassis Cover 1d Top View 6KPM retaining screws hold Face Plate Installing 6KPM Cards in the Magnum 6K32TWww . GarrettCom . com 2g Top View 6KPM Module installed inside a 6K32T Switch Firmly. .5.3a Top View 6 retaining screws shown by arrows Removing 6KPM CardsRear View of Magnum 6K32T Connecting the Console Terminal to Magnum 6K32T ManagementConsole DB-9 Port Remove 6KPM Card1 RS-232 DB-9 Console Com port Serial port pin assignments Pin Signal DescriptionSwitching Functionality DB-9 Console port connectorPWR Status LEDsACT Auto-Cross MDIXAuto-negotiation, for 10/100Mbps RJ-45 ports Www . GarrettCom . com Flow-control, Ieee 802.3x standard Magnum 6K32T Managed Switch Port Modules6KPM Module Description 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module Flstfx is a combo fiber Connectors and configuredAs 10Mb Half-duplex by Default for 10Mb fiber Magnum 6KP4Activity ACT, Link LK, Mode 100Mbps fiber opticMode SC-type connectors. It Transceivers all in one module. ThisWww . GarrettCom . com Link 6KP8-MTRJPort@ 100Mbps Multi-Mode Fiber port Activity FULL/HALF7 6KP8-MLC, 8 ports @ 100Mbps multi-mode LC connector Small 9 6KP8-RJ45 Twisted Pair, 10/100Mb 8-Port Give an advantage of placing more Small size of LC connectorsPorts on one module. The 6KP8-45 11a GBIC-LXSC Gigabit fiber 1000Mb, multi-mode SC Connector GBIC-SXSC Gigabit fiber1000Mb, multi-mode SC Connector@ 1000Mb Fiber SC @ 1000Mb Fiber SC + 2@ 100Mb SCBefore Calling for Assistance 12 6KM-BLNKReturn Material Authorization RMA Procedure When Calling for AssistanceShipping and Packaging Information No Problem FoundB1.0 Specifications for Magnum 6K32T SWITCHES, DC Power Appendix B Internal DC Power Supply OptionsPower Supply Internal -48VDC Option B4.0 Installation B3.0 Applications for DC Powered SwitchesB6.0 Ordering Information Appendix C Internal DC Dual-Source Power OptionB7.0 Troubleshooting B5.0 OperationC4.0 Features and Benefits of the DUAL-SOURCE Design C5.0 Installation C7.0 Operation C5.1 UL RequirementsC6.0 Ordering Information Example Magnum 6K32T & 6K32-48VDC
Top Page Image Contents