GarrettCom Magnum 6K32T user manual 12 6KM-BLNK, Before Calling for Assistance

Page 59

Magnum 6K32 & 6K32T Managed Switch

Installation and User Guide (12/05)

5.2.12 6KM-BLNK

 

 

 

 

 

 

 

 

 

 

The 6K8-BLNK is a

 

 

 

 

 

blank face plate or cover plate that

 

 

 

 

 

must be installed in any empty

 

 

 

 

 

6K32T PM slot to maintain proper

 

 

 

 

 

cooling air flow, safety, etc.

 

 

 

 

 

 

 

 

 

 

Two screws underneath the front panel hold the 6KM-BLNK in place.

6.0TROUBLESHOOTING

All Magnum Ethernet products are designed to provide reliability and

consistently high performance in all network environments. The installation of a Magnum 6K32T Switch is a straightforward procedure (see INSTALLATION, Section 3.0); the operation is also straightforward and is discussed in Section 4.

Should problems develop during installation or operation, this section is intended to help locate, identify and correct these types of problems. Please follow the suggestions listed below prior to contacting your supplier. However, if you are unsure of the procedures described in this section or if the Magnum 6K32T Switch is not performing as expected, do not attempt to repair the unit; instead contact your supplier for assistance or contact GarrettCom Customer Support.

6.1Before Calling for Assistance

1.If difficulty is encountered when installing or operating the unit, refer back to the Installation Section of the applicable chapter of this manual. Also check to make sure that the various components of the network are interoperable.

2.Check the cables and connectors to ensure that they have been properly connected and the cables/wires have not been crimped or in some way impaired during installation. (About 90% of network downtime can be attributed to wiring and connector problems.)

3.Make sure that an AC power cord is properly attached to each Magnum 6K32T Switch unit. Be certain that each AC power cord is plugged into a functioning electrical outlet. Use the PWR LEDs to verify each unit is receiving power.

4.If the problem is isolated to a network device other than the Magnum 6K32T Switch product, it is recommended that the problem device be replaced with a known good device. Verify whether or not the problem is corrected. If not, go to Step 5 below. If the problem is corrected, the Magnum 6K32T Switch and its associated cables are functioning properly.

www . GarrettCom . com

53

Page 58 Page 60
Image 59
Page 58 Page 60
Contents Managed Switch Trademarks Canadian Emission Contacting GarrettCom, IncIntroduction Table of ContentsMagnum 6K32T Managed Switch Port Modules Personal Hubs, 10Mb series Personal Switches, 10/100MbTechnical Specifications LEDs Per Port Fiber connector types supportedManagement Console connector Power Supply InternalAgency Approvals Relay Alarm Contact OptionalPer-port MDI or Mdix on RJ-45 Gigabit Transceiver options Configuration OptionsOrdering Information Magnum 6K32T Port ModulesWww . GarrettCom . com Introduction Inspecting the Package and Product Product Description Magnum 6K32T Managed Switch 1a Magnum 6K32T Chassis 1b New Magnum 6K32T Chassis 100Mb fiber eight Port modules for the Magnum Mode for best fiber distanceEight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb fiber Eight-Port Copper Module, 6K8-RJ45 ST or SC Four-Port 10 Mb mm Fiber ST Modules@RJ-45 + 2@ 100Mb Gigabit 1000Mbps port modules Frame Buffering and Flow Control Packet Prioritization, 802.1p QOSMIBs for Snmp visit Managed Network Software MNS-6K for Magnum 6K32T„ Features Fiber-Built-In Features and Benefits„ Managed switching for high performance Ethernet LANs Applications Example 1 Magnum 6K32T Switch for a Vlan applicationData Example 3 Redundant Application Www . GarrettCom . com Www . GarrettCom . com Locating Magnum 6K32T Switches InstallationCopper Connecting Ethernet MediaConnecting Fiber Optic ST-type, twist-lock Ieee Standard Media Type Max. Distance Port Module FiberMedia Ieee Standard Connecting Fiber Optic SC-type, Snap-InConnecting Single-Mode Fiber Optic Twisted Pair CAT-5e 1000BASE-T F10ST Magnum 6K32T unit. These Table-Top or Shelf MountingRack-mounting for 19 Retma racks, Magnum 6K32T’s 1 Dual Side-Mountings for Magnum 6K32T units Rack-mounting, Reverse version of the Magnum 6K32T’sPowering the Magnum 6K32T Managed Switch Preparation for Installing and Removing 6KPMs 6K32T Port Module 6KPM InstallationRemove Chassis Cover 1d Top View 6KPM retaining screws hold Face Plate Installing 6KPM Cards in the Magnum 6K32TWww . GarrettCom . com 2g Top View 6KPM Module installed inside a 6K32T Switch Firmly. .5.3a Top View 6 retaining screws shown by arrows Removing 6KPM CardsRear View of Magnum 6K32T Connecting the Console Terminal to Magnum 6K32T ManagementConsole DB-9 Port Remove 6KPM Card1 RS-232 DB-9 Console Com port Serial port pin assignments Pin Signal DescriptionSwitching Functionality DB-9 Console port connectorACT Status LEDsPWR Auto-Cross MDIXAuto-negotiation, for 10/100Mbps RJ-45 ports Www . GarrettCom . com Flow-control, Ieee 802.3x standard Magnum 6K32T Managed Switch Port Modules6KPM Module Description 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module Flstfx is a combo fiber Connectors and configuredAs 10Mb Half-duplex by Default for 10Mb fiber Magnum 6KP4Activity ACT, Link LK, Mode 100Mbps fiber opticMode SC-type connectors. It Transceivers all in one module. ThisWww . GarrettCom . com Link 6KP8-MTRJPort@ 100Mbps Multi-Mode Fiber port Activity FULL/HALF7 6KP8-MLC, 8 ports @ 100Mbps multi-mode LC connector Small 9 6KP8-RJ45 Twisted Pair, 10/100Mb 8-Port Ports on one module. The 6KP8-45 Small size of LC connectorsGive an advantage of placing more 11a GBIC-LXSC Gigabit fiber 1000Mb, multi-mode SC Connector GBIC-SXSC Gigabit fiber1000Mb, multi-mode SC Connector@ 1000Mb Fiber SC @ 1000Mb Fiber SC + 2@ 100Mb SCBefore Calling for Assistance 12 6KM-BLNKReturn Material Authorization RMA Procedure When Calling for AssistanceShipping and Packaging Information No Problem FoundPower Supply Internal -48VDC Option Appendix B Internal DC Power Supply OptionsB1.0 Specifications for Magnum 6K32T SWITCHES, DC Power B4.0 Installation B3.0 Applications for DC Powered SwitchesB6.0 Ordering Information Appendix C Internal DC Dual-Source Power OptionB7.0 Troubleshooting B5.0 OperationC4.0 Features and Benefits of the DUAL-SOURCE Design C5.0 Installation C7.0 Operation C5.1 UL RequirementsC6.0 Ordering Information Example Magnum 6K32T & 6K32-48VDC
Top Page Image Contents