GarrettCom 6K32 manual Gigabit 1000Mbps port modules, Packet Prioritization, 802.1p QOS

Page 18

Magnum 6K32 Managed Switch

Installation and User Guide (02/05)

2.2.6Gigabit (1000Mbps) port modules

The Magnum 6K32 offered a wide option Gigabit speed with multiple choice

for the modular slot. While up to two Gigabit modules (maxm.) can be configured in the modular slot. The Gigabit port option for the modular slot comes in couple of different configuration. The two Giga port has been offered as GBPM-2OTX (fiber or RJ-45), whereas the single Gigabit module comes in flavor of G+4(10/100 RJ-45 ports) or G+2 (100Mb fiber ports) as shown below in the figure.

ACT F/

ACT

F/ 2

ACT

F/

 

 

 

 

 

 

TX

LK RX

3

TX

LK RX

 

 

 

1

 

 

 

 

10/100

 

 

 

 

 

ACT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

6

 

 

 

 

 

 

 

 

F/

 

 

F/

 

 

TX

L

RX

TX

LK

RX

 

 

 

 

 

5 7

L

ACT

1@ 1000Mb Fiber SC + 2@ 100Mb SC

1@ 1000Mb Fiber SC + 4@10/ 100Mb

The 6K32 modules provide a GBIC opening for insertion of industry-standard GBICs to provide Gigabit (Gb) media flexibility. GBIC models are available for both multi-mode (550m) and single-mode (10, 25, 40, 70)km fiber options, and for Gigabit copper as well, with new models appearing often.

The 1000Mb Gigabit fiber-port modules on the Magnum 6K32 are normally set (factory default) to operate at AUTO mode for best fiber distance and performance. The 1000Mbps SC fiber-optic module on the Gigabit -SX and Gigabit-LX transceivers are compatible with the IEEE 802.3z Gigabit standards.

There are two LEDs mounted on each Gigabit port module. The Gigabit fiber port is by default configured at AUTO mode, and can be fix at 1000Mbps speed full- duplex mode at any times and has LEDs that indicate LK (Link status) and ACT (receiving activity) on that port when lit.

2.2.7Packet Prioritization, 802.1p QOS

Quality of Service means providing consistent predictable data delivery to

users from datagram paths that go all across a network. As a LAN device, the Magnum 6K32 can do its part to prevent any QOS degradation while it is handling Ethernet traffic through its ports and buffers.

The Magnum 6K32 switching hardware supports the IEEE 802.1p standard and

www . GarrettCom . com

12

Image 18
Contents GarrettCom, Inc Corporate HeadquartersTrademarks Table of Contents Contacting GarrettCom, IncCanadian Emission Introduction Troubleshooting Personal Switches, 10/100Mb Personal Hubs, 10Mb seriesTechnical Specifications Power Supply Internal Fiber connector types supportedManagement Console connector DC Power Supply OptionsAlarm Contact Optional Manual switches for modular slot port module onlyAgency Approvals Ordering Information 6KP8-45-2MT 6KP8-45-2SLC LC connectors Gigabit Transceiver optionsIntroduction Inspecting the Package and Product Product Description Magnum 6K32 Managed Switch Magnum 6K32 and 6K32R chassis Mode for best fiber distance Eight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb fiber100Mb fiber eight Port modules for the Magnum Eight-Port Copper Module, 6K8-RJ45 @ RJ-45 + 2@ 100Mb SC@ RJ-45 + 2@ 100Mb ST Four-Port 10 Mb mm Fiber ST Modules Gigabit 1000Mbps port modules Packet Prioritization, 802.1p QOSFrame Buffering and Flow Control Managed Network Software MNS-6K for Magnum 6K32 Features and Benefits „ Managed switching for high performance Ethernet LANs„ Features Fiber-Built-In Example 1 Magnum 6K32 Switch for a Vlan application ApplicationsInternet Example 3 Redundant Application InternetSwitch #1 Installation Locating Magnum 6K32 SwitchesConnecting Ethernet Media Ieee Standard Media Type Max. Distance Port Module Fiber Connecting Fiber Optic ST-type, twist-lockConnecting Fiber Optic SC-type, Snap-In CopperConnecting Single-Mode Fiber Optic Media Ieee StandardTable-Top or Shelf Mounting Rack-mounting for 19 Retma racks, regular Magnum 6K32sMagnum 6K32 unit. These Rack-mounting, Reverse version of the Magnum 6K32s 1 Mountings for Magnum 6K32 units rack-mounted in a framePowering the Magnum 6K32 Managed Switch 2 Reverse Magnum 6K32 units, rack- mounted in a frame6K32 Port Module 6KPM Installation Preparation for Installing and Removing 6KPMsRemove Chassis Cover 1a Removing front panel after the screws being removed1b Pulling out the top coved from the chassis base Installing 6KPM Cards in the Magnum 6K32 1d Top View 6KPM retaining screws hold Face PlateSecurely latching up 6KPM Cards into a Magnum 6K32 2g Top View 6KPM Module installed inside a 6K32 Switch Removing 6KPM CardsRemoving a 6KPM Card DB-9 Console port connector Connecting the Console Terminal to Magnum 6K32 ManagementPin Signal Description Console DB-9 PortSwitching Functionality Filtering and ForwardingPWR Status LEDsAuto-Cross MDIXAuto-negotiation, for 10/100Mbps RJ-45 ports ACTWww . GarrettCom . com Flow-control, Ieee 802.3x standard 6KP4 ’cvrMagnum 6K32 Managed Switch Port Modules 6KPM Module Description 1b 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module Magnum 6KP4 Connectors and configuredAs 10Mb Half-duplex by Default for 10Mb fiber Flstfx is a combo fiberCopper ports and 2 Single Mode SC-type connectors. ItEquipped with 4 dual speed Provides an advantage Through combining copperWww . GarrettCom . com Port@ 100Mbps Multi-Mode Fiber port Activity FULL/HALFLink Copper and fiber Small Form Factor Magnum 6KP8-45MTModule is a combo module with Placing more ports on one module9 6KP8-RJ45 Twisted Pair, 10/100Mb 8-Port 10a 6KP8-45-2LC, 6@ 10/100Mbps RJ-45 and 2@100Mb single-mode GBIC-SXSC Gigabit fiber1000Mb, multi-mode SC Connector FX , LC Small-Form-Factor11a GBIC-LXSC Gigabit fiber 1000Mb, multi-mode SC Connector 12 6KM-BLNK@ 1000Mb Fiber SC + 2@ 100Mb SC When Calling for Assistance Before Calling for AssistanceReturn Material Authorization RMA Procedure No Problem FoundPower Supply Internal -48VDC Option Appendix B Internal DC Power Supply OptionsB1.0 Specifications for Magnum 6K32 SWITCHES, DC Power Shipping and Packaging InformationPower Supply Internal 125 VDC Option Industrial Applications B3.0 Applications for DC Powered SwitchesB4.0 Installation B4.1 UL Requirements for DC-powered unitsB5.0 Operation B7.0 Troubleshooting B6.0 Ordering InformationAppendix C Internal DC Dual-Source Power Option GNDC4.0 Features and Benefits of the DUAL-SOURCE Design C5.0 InstallationExample Magnum 6K32R-48VDC C5.1 UL RequirementsC6.0 Ordering Information Example Magnum 6K32R-24VDC or Magnum 6K32R-125VDC