GarrettCom 6K32 Fiber connector types supported, LEDs Per Port, Operating Environment, Packaging

Page 8

Magnum 6K32 Managed Switch Installation and User Guide (02/05)

Fiber connector types supported:

ST-type (twist-lock)

SC-type (snap-in)

MTRJ-type Small Form Factor (SFF)

LC-type Small Form Factor (SFF)

GBIC modules

LEDs: Per Port

LK: Steady ON when media link is operational

ACT: ON with receiver port activity

FDX/HDX: ON = Full-Duplex Mode OFF = Half-Duplex Mode

100/10: ON = 100Mbps speed OFF = 10 Mbps

Operating Environment

Ambient Temperature: 25° to 130° F (-5° to 55°C)

Storage Temperature: -40°to 185°F (-40°to 85°C)

Ambient Relative Humidity: 5% to 95% (non-condensing)

Altitude: -200 to 13,000 ft. (-60 to 4000m)

Conformal Coating option: Request quote

Packaging

Enclosure: Rugged High strength metal. Suitable for stand-alone or rack-mounting

Dimensions: 1.70in. H x 17.0in. W x 9.0in. D 4.32cm H x 43.2cm W x 22.9cm D

Cooling method: Fan cooled, @ 3@ 7 cfm ea.

Management Console connector

DB-9 for RS-232 “ null-modem “ cable (sometimes called an X-modem cable)

Power Supply (Internal)

AC Power Connector: IEC-type, male recessed at rear of chassis,

with adjacent manual ON-OFF switch (optional if no Alarms Cont.) Input Voltage: 100 to 240 VAC (auto-ranging)

Input Frequency: 47 to 63 Hz (auto-ranging)

Power Consumption: 45 watts max (with fiber module)

30 watts for a fully-loaded copper only model

DC Power Supply (Options)

-48VDC Power Input Voltage : -36 to -70 VDC

24VDC Power Input Voltage : 20 to 40VDC

125VDC Power and 100VDC Input Voltage : 88 to 150VDC

Std. Terminal Block : “ -, GND, + ”

Power Consumption: same as for AC models, see above

For (Optional) DC internal power supplies at –48VDC, 24VDC and 125VDC, including Dual Source options (for continuity of operation when either of the DC input sources are interrupted), see Appendices B and C.

www . GarrettCom . com

2

Image 8

Contents GarrettCom, Inc Corporate HeadquartersTrademarks Canadian Emission Table of ContentsContacting GarrettCom, Inc Introduction Troubleshooting Personal Switches, 10/100Mb Personal Hubs, 10Mb seriesTechnical Specifications Fiber connector types supported Management Console connectorPower Supply Internal DC Power Supply OptionsAgency Approvals Alarm Contact OptionalManual switches for modular slot port module only Ordering Information 6KP8-45-2MT 6KP8-45-2SLC LC connectors Gigabit Transceiver optionsIntroduction Inspecting the Package and Product Product Description Magnum 6K32 Managed Switch Magnum 6K32 and 6K32R chassis 100Mb fiber eight Port modules for the Magnum Mode for best fiber distanceEight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb fiber @ RJ-45 + 2@ 100Mb ST Eight-Port Copper Module, 6K8-RJ45@ RJ-45 + 2@ 100Mb SC Four-Port 10 Mb mm Fiber ST Modules Gigabit 1000Mbps port modules Packet Prioritization, 802.1p QOSFrame Buffering and Flow Control Managed Network Software MNS-6K for Magnum 6K32 „ Features Fiber-Built-In Features and Benefits„ Managed switching for high performance Ethernet LANs Example 1 Magnum 6K32 Switch for a Vlan application ApplicationsInternet Example 3 Redundant Application InternetSwitch #1 Connecting Ethernet Media InstallationLocating Magnum 6K32 Switches Connecting Fiber Optic ST-type, twist-lock Connecting Fiber Optic SC-type, Snap-InIeee Standard Media Type Max. Distance Port Module Fiber CopperConnecting Single-Mode Fiber Optic Media Ieee StandardMagnum 6K32 unit. These Table-Top or Shelf MountingRack-mounting for 19 Retma racks, regular Magnum 6K32s Rack-mounting, Reverse version of the Magnum 6K32s 1 Mountings for Magnum 6K32 units rack-mounted in a framePowering the Magnum 6K32 Managed Switch 2 Reverse Magnum 6K32 units, rack- mounted in a frame6K32 Port Module 6KPM Installation Preparation for Installing and Removing 6KPMsRemove Chassis Cover 1a Removing front panel after the screws being removed1b Pulling out the top coved from the chassis base Installing 6KPM Cards in the Magnum 6K32 1d Top View 6KPM retaining screws hold Face PlateSecurely latching up 6KPM Cards into a Magnum 6K32 2g Top View 6KPM Module installed inside a 6K32 Switch Removing 6KPM CardsRemoving a 6KPM Card Connecting the Console Terminal to Magnum 6K32 Management Pin Signal DescriptionDB-9 Console port connector Console DB-9 PortSwitching Functionality Filtering and ForwardingStatus LEDs Auto-Cross MDIXAuto-negotiation, for 10/100Mbps RJ-45 portsPWR ACTWww . GarrettCom . com Flow-control, Ieee 802.3x standard 6KP4 ’cvrMagnum 6K32 Managed Switch Port Modules 6KPM Module Description 1b 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module Connectors and configured As 10Mb Half-duplex by Default for 10Mb fiberMagnum 6KP4 Flstfx is a combo fiberMode SC-type connectors. It Equipped with 4 dual speedCopper ports and 2 Single Provides an advantage Through combining copperWww . GarrettCom . com Link Port@ 100Mbps Multi-Mode Fiber portActivity FULL/HALF Magnum 6KP8-45MT Module is a combo module withCopper and fiber Small Form Factor Placing more ports on one module9 6KP8-RJ45 Twisted Pair, 10/100Mb 8-Port 10a 6KP8-45-2LC, 6@ 10/100Mbps RJ-45 and 2@100Mb single-mode GBIC-SXSC Gigabit fiber1000Mb, multi-mode SC Connector FX , LC Small-Form-Factor@ 1000Mb Fiber SC + 2@ 100Mb SC 11a GBIC-LXSC Gigabit fiber 1000Mb, multi-mode SC Connector12 6KM-BLNK When Calling for Assistance Before Calling for AssistanceReturn Material Authorization RMA Procedure No Problem FoundAppendix B Internal DC Power Supply Options B1.0 Specifications for Magnum 6K32 SWITCHES, DC PowerPower Supply Internal -48VDC Option Shipping and Packaging InformationPower Supply Internal 125 VDC Option Industrial Applications B3.0 Applications for DC Powered SwitchesB5.0 Operation B4.0 InstallationB4.1 UL Requirements for DC-powered units B7.0 Troubleshooting B6.0 Ordering InformationAppendix C Internal DC Dual-Source Power Option GNDC4.0 Features and Benefits of the DUAL-SOURCE Design C5.0 InstallationC5.1 UL Requirements C6.0 Ordering InformationExample Magnum 6K32R-48VDC Example Magnum 6K32R-24VDC or Magnum 6K32R-125VDC