GarrettCom 6K32 manual Connecting Single-Mode Fiber Optic, Media Ieee Standard

Page 28

Magnum 6K32 Managed Switch

Installation and User Guide (02/05)

3.2.3Connecting Single-Mode Fiber Optic

When using single-mode fiber cable, be sure to use single-mode fiber port

connectors. Single-mode fiber cable has a smaller diameter than multi-mode fiber cable (9/125 microns for single-mode, 50/125 or 62.5/125 microns for multi-mode where xx/xx are the diameters of the core and the core plus the cladding respectively). Single-mode fiber allows full bandwidth at longer distances, and may be used to connect 10 Mb nodes up to 10 Km apart, or 18Km with the 6K-SSC.

The same procedures as for multi-mode fiber applies to single-mode fiber connectors. Follow the steps listed in Section 3.2.2 above.

3.2.4Connecting Twisted Pair (RJ-45,CAT3, CAT5, Unshielded or Shielded) The RJ-45 ports of the Magnum 6K32 can be connected to the following two

media types: 100BASE-TX and 10BASE-T. CAT 5 cables should be used when making 100BASE-TX connections. When the ports are used as 10BASE-T ports, CAT 3 may be used. In either case, the maximum distance for unshielded twisted pair cabling is 100 meters (328 ft).

Media

IEEE Standard

Connector

Twisted Pair (CAT 3, 4, 5)

10BASE-T

RJ-45

Twisted Pair (CAT 5)

100BASE-TX

RJ-45

NOTE : It is recommended that high quality CAT. 5 cables (which work for both 10 Mb and 100Mb) be used whenever possible in order to provide flexibility in a mixed-speed network, since dual-speed ports are auto-sensing for either 10 and 100Mb/s.

The following procedure describes how to connect a 10BASE-T or 100BASE- TX twisted pair segment to the RJ-45 port. The procedure is the same for both unshielded and shielded twisted pair cables.

1.Using standard twisted pair media, insert either end of the cable with an RJ-45 plug into the RJ-45 connector of the port. Note that, even though the connector is shielded, either unshielded or shielded cables and wiring may be used.

2.Connect the other end of the cable to the corresponding device

3.Use the LINK LED to ensure proper connectivity by noting that the LED will be illuminated when the unit is powered and proper connection is established

3.2.5Connecting Twisted Pair (CAT5E or better, Unshielded or Shielded) The RJ-45 Gigabit ports of the Magnum 6K32 can be connected to the media

types, 1000BASE-T or CAT 5E or better 100-ohm UTP or shielded twisted pair (STP) balanced cable. The CAT 5E or better 100-ohm UTP or shielded twisted pair (STP) balanced cable is recommended to use when making 1000BASE-TX connections. In either case, the maximum distance for unshielded twisted pair cabling is 100 meters (328 ft). See Section 4.3 for manual Up-Link switch on port 1 of copper port modules.

www . GarrettCom . com

22

Image 28
Contents GarrettCom, Inc Corporate HeadquartersTrademarks Contacting GarrettCom, Inc Table of ContentsCanadian Emission Introduction Troubleshooting Personal Switches, 10/100Mb Personal Hubs, 10Mb seriesTechnical Specifications Fiber connector types supported Management Console connectorPower Supply Internal DC Power Supply OptionsManual switches for modular slot port module only Alarm Contact OptionalAgency Approvals Ordering Information 6KP8-45-2MT 6KP8-45-2SLC LC connectors Gigabit Transceiver optionsIntroduction Inspecting the Package and Product Product Description Magnum 6K32 Managed Switch Magnum 6K32 and 6K32R chassis Eight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb fiber Mode for best fiber distance100Mb fiber eight Port modules for the Magnum @ RJ-45 + 2@ 100Mb SC Eight-Port Copper Module, 6K8-RJ45@ RJ-45 + 2@ 100Mb ST Four-Port 10 Mb mm Fiber ST Modules Gigabit 1000Mbps port modules Packet Prioritization, 802.1p QOSFrame Buffering and Flow Control Managed Network Software MNS-6K for Magnum 6K32 „ Managed switching for high performance Ethernet LANs Features and Benefits„ Features Fiber-Built-In Example 1 Magnum 6K32 Switch for a Vlan application ApplicationsInternet Example 3 Redundant Application InternetSwitch #1 Locating Magnum 6K32 Switches InstallationConnecting Ethernet Media Connecting Fiber Optic ST-type, twist-lock Connecting Fiber Optic SC-type, Snap-InIeee Standard Media Type Max. Distance Port Module Fiber CopperConnecting Single-Mode Fiber Optic Media Ieee StandardRack-mounting for 19 Retma racks, regular Magnum 6K32s Table-Top or Shelf MountingMagnum 6K32 unit. These Rack-mounting, Reverse version of the Magnum 6K32s 1 Mountings for Magnum 6K32 units rack-mounted in a framePowering the Magnum 6K32 Managed Switch 2 Reverse Magnum 6K32 units, rack- mounted in a frame6K32 Port Module 6KPM Installation Preparation for Installing and Removing 6KPMsRemove Chassis Cover 1a Removing front panel after the screws being removed1b Pulling out the top coved from the chassis base Installing 6KPM Cards in the Magnum 6K32 1d Top View 6KPM retaining screws hold Face PlateSecurely latching up 6KPM Cards into a Magnum 6K32 2g Top View 6KPM Module installed inside a 6K32 Switch Removing 6KPM CardsRemoving a 6KPM Card Connecting the Console Terminal to Magnum 6K32 Management Pin Signal DescriptionDB-9 Console port connector Console DB-9 PortSwitching Functionality Filtering and ForwardingStatus LEDs Auto-Cross MDIXAuto-negotiation, for 10/100Mbps RJ-45 portsPWR ACTWww . GarrettCom . com Flow-control, Ieee 802.3x standard 6KP4 ’cvrMagnum 6K32 Managed Switch Port Modules 6KPM Module Description 1b 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module Connectors and configured As 10Mb Half-duplex by Default for 10Mb fiberMagnum 6KP4 Flstfx is a combo fiberMode SC-type connectors. It Equipped with 4 dual speedCopper ports and 2 Single Provides an advantage Through combining copperWww . GarrettCom . com Activity FULL/HALF Port@ 100Mbps Multi-Mode Fiber portLink Magnum 6KP8-45MT Module is a combo module withCopper and fiber Small Form Factor Placing more ports on one module9 6KP8-RJ45 Twisted Pair, 10/100Mb 8-Port 10a 6KP8-45-2LC, 6@ 10/100Mbps RJ-45 and 2@100Mb single-mode GBIC-SXSC Gigabit fiber1000Mb, multi-mode SC Connector FX , LC Small-Form-Factor12 6KM-BLNK 11a GBIC-LXSC Gigabit fiber 1000Mb, multi-mode SC Connector@ 1000Mb Fiber SC + 2@ 100Mb SC When Calling for Assistance Before Calling for AssistanceReturn Material Authorization RMA Procedure No Problem FoundAppendix B Internal DC Power Supply Options B1.0 Specifications for Magnum 6K32 SWITCHES, DC PowerPower Supply Internal -48VDC Option Shipping and Packaging InformationPower Supply Internal 125 VDC Option Industrial Applications B3.0 Applications for DC Powered SwitchesB4.1 UL Requirements for DC-powered units B4.0 InstallationB5.0 Operation B7.0 Troubleshooting B6.0 Ordering InformationAppendix C Internal DC Dual-Source Power Option GNDC4.0 Features and Benefits of the DUAL-SOURCE Design C5.0 InstallationC5.1 UL Requirements C6.0 Ordering InformationExample Magnum 6K32R-48VDC Example Magnum 6K32R-24VDC or Magnum 6K32R-125VDC