GarrettCom 6K32 manual 10a 6KP8-45-2LC, 6@ 10/100Mbps RJ-45 and 2@100Mb single-mode

Magnum 6K32 Managed Switch Installation and User Guide (02/05)

special twisted pair crossover cable when connecting to a hub or another switch.

The switch is configured as (=) position by default settings from the factory, the left-most RJ-45 port is used for segments going to workstations and other user node device connections as other ports of the module. For cascaded and up-link connections (i.e.: a connection to another hub or switch typically), the uplink switch should be in the OUT

(X) position.

Each port has an Activity (ACT) LED indicating packets being received, a Link (LK) LED that indicates proper connectivity with the remote device when lit, a FDX/HDX LED to indicate full-duplex mode when lit (or half-duplex when off), and a “10/100” LED indicating 100Mb when lit (or 10 Mbps when off).

Important Note: For the 6KP8-RJ45 Crossover Switch-Inside

is set for (=) by default from the factory for the Port # 1

and act similar as other user port. The location of crosss-over switch can be seen in the fig 3.5.2.c( RJ-45 module) at page no 27.

The RJ-45 pins normally (TP crossover switch) are per the standard for hubs-to- users twisted pair wiring: 1 = receive+, 2 = receive-, 3 = transmit+, 6 = transmit-, other pins not used. When the TP crossover push-button is UP, the pins of the RJ- 45 port are per the standard for up-links using twisted pair wiring, i.e., the transmit and the receive pairs are exchanged: 1 = transmit+, 2 = transmit-, 3 = receive+, 6 = receive-, other pins not used.

5.2.106KP8-45-2MT, 6@ 10/100Mbps RJ-45 and 2@100Mb multi-mode FX , MTRJ Small-Form-Factor

The Magnum 6KP8-		6KP86KP8V- -45-2MT
45-2MT eight port Module is a	6 Port@10/10Mbps			and 2 port @100Mb
combo module with copper and	Multi-Mode Fiber port
			2
fiber (Small Form Factor)		1	3	5		1
MTRJ type ports. The small		10/10			L
	4
sizes of MTRJ connectors give		F/H			AC
		10/100			ACT
					F/H
					ACT
an advantage of placing more		F/H 2	4	LK	F/H	3
					6
fiber ports on one module. The	1	LINK		2	10/100
6KP8-45-2MT is equipped with
				4
six 10/100 RJ-45 ports and two	3	ACTIVITY			FULL/HALF

100Mb MTRJ fiber ports. When installed in a Magnum 6K32 Switch, it supports the standard distances as mentioned on 5.2.3. and the LEDs also act similarly.

5.2.10a 6KP8-45-2LC, 6@ 10/100Mbps RJ-45 and 2@100Mb single-mode

www . GarrettCom . com

48