GE Series 90-70 manual Chapter Installation, Installing the I/O Link Interface Module in the Rack

Page 19

Chapter

2

Installation

This chapter tells how to install an I/O Link Interface Module, and how to complete the I/O Link that joins the module to other devices.

Installing the I/O Link Interface Module in the Rack

The I/O Link Interface Module must not be located to the left of any board that generates interrupts (such as a PCM, Genius Bus Controller, Analog, GEnet LAN, or Ethernet module).

Caution

Rack power MUST be OFF when installing or removing the I/O Link

Module.

1.Grasp the module firmly with your hand and insert it into the card guide.

2.Align the module's printed circuit board with the connector on the rack backplane and slide it towards the connector until it has started to seat.

3.Place one thumb on the left side of the top plastic flange and the other thumb on the left side of the bottom plastic flange. Push the board into the connector until the top and bottom latches click onto the rack rails.

4.Visually inspect the board to be sure it has seated properly.

Caution

Make sure no exposed wiring touches any conductive material. Such contact could damage the module, and other units to which it is connected.

GFK-0644A

15

Image 19

Contents GE Fanuc Automation GFL±002 Related Publications Content of this ManualWe Welcome Your Comments and Suggestions Contents System Overview Chapter IntroductionMaster or Slave Operation Application Software LEDs Module DescriptionReset Pushbutton Module SpecificationsSerial Ports CatalogNumber Cable Types for the I/O LinkCable Lengths on the I/O Link Optical Adapter Input and Output Data Operation of the I/O LinkData Returned by Slaves Data Sent by the MasterInputs and Outputs Hold Last State Faults on the I/O Link Link Control DiagnosticsGetting Started Install the module and complete the I/O LinkComplete the program logic for the I/O Link Module Installing the I/O Link Interface Module in the Rack Chapter InstallationLED Name LED Status Indication Removing the I/O Link Interface Module from the RackPorts on the I/O Link Module Connecting the I/O Link Interface Module to Other DevicesLink Module Used as a Master Link Module Used as a Slave Serial Port Pin AssignmentsOrder of the Devices on the Link Cable Diagram, No Optical Adapter Cable Diagram, Electrical Cable to Optical Adapter Optical Adapter InstallationCable Connections Configuration Steps Chapter Logicmaster 90-70 ConfigurationGFK-0644A Overview Chapter Programming GuideAdding the Program Block Logic to an Application Program Selecting a Program BlockCalling the Program Block Using Multiple Calls to the Program BlockExample Call Instruction 3rdModule 4thModule Program %P References for the I/O Link Program BlocksGlobal %G References for the I/O Link Program Blocks Using Nicknames for the %P ReferencesConfiguration Logic, Example Configuring I/O LinksSpecify the Number of I/O Link Modules Configuration GuidelinesStart/Restart bit Set Master or Slave Mode bitReset or Stop bit Controlling the I/O Link ModuleDisable or Enable the Output Update bit Disable or Enable the Input Update bitMonitor the Module bit Monitoring Link OperationMonitor Communications Status bit Monitor for Link Failure bit Monitor for an Invalid Configuration or Link Fault bitError Description RecommendedAction Code Error Codes TroubleshootingConfiguration Error Codes Index GFK-0644A Index