5.0 DISPLAY & CONTROLS
The pictures below outline the various control panel, LED and LCD functions and locations.
5.1 Control Button and LCD Locations
1.LCD Display
2.N+1 Status LED
3.Utility Status Indicator LED
4.Bypass Input Status LED
5.UPS On / Alarm Silence Control Button
6.Previous Page / Change Setting Button
7.Confirm Button
8.Next Page Button
9.UPS Off / Bypass Button
10.Function Button
11.Economy/Green Mode Status LED
12.UPS Alarm LED
5.2 Control Button Operation
On/Alarm Silence Button
1. When utility power is present and the UPS input circuit breakers are in the “On” position, depressing and holding this button for 5 seconds will turn on the UPS.
2. When utility power is not present or the UPS input circuit breaker is in the “Off” position, depressing and holding this button for 5 seconds will initiate a preliminary startup sequence. When “Off” or “BPS” is displayed on the LCD, depressing the “On” button again for 6 seconds will start up the UPS in battery mode (cold start).
3. When the UPS is in utility or battery mode, depressing this button will silence any audible alarms.
Off/Bypass Button
2.
1.When the UPS is operating in utility or battery mode, depressing and holding this button until an
audible beep is sounded will leave the load powered in bypass mode. To completely shut down the UPS and connected load, press the Off/Bypass button until “Off” is displayed on the LCD, and then turn off the UPS and Bypass input circuit breakers. The UPS will shut down in about one minute.
Control Panel
When the LCD is in the “Display Programmed Settings” mode, depressing the Function Button will return the LCD to normal mode.
The LCD display will also return to “Normal Mode” automatically after 30 seconds of button inactivity.
Previous Page/Change Setting Button
Function Button
1.When the UPS is operating in utility or battery mode, depressing the Function Button will switch the LCD to display the “Programmed Parameter” settings. When in this mode, depressing the “Next Page” button will display the next programmed parameter setting. Repeatedly depress the “Next Page” button to display all of the programmed parameter settings.
1.When the LCD display is in “Normal Mode”, repeated pressing of this button will sequence up through the input/output/battery parameters and readings will be displayed.
2.When in “Programming Mode”, pressing this button will change the selected parameter setting. The new setting will be displayed on the LCD Measurement display.
15