Falcon FN6KRM-2TXI, FN4KRM-2TXI, FN3KRM-2TXI manual How to Change the Programmed Settings

Page 27

6.7 How to Change the Programmed Settings

Note: The UPS must be placed into Off / Bypass mode prior to attempting to change the following parameter settings.

1.To enter programming mode depress the “On” and “Next Page” buttons at the same time and hold them down until the UPS sounds two beeps. The audible alarm status parameter setting will be displayed.

The audible alarm parameter settings cannot be set in this programming mode. Refer to section 6 of this manual for setup instructions.

Depress the “Next Page” button.

Self-test parameter settings cannot be set in this programming mode. Refer to section 6 of this manual for setup instructions.

Depress the “Next Page” button and go to the next page.

27

Image 27

Contents Owners Operating Manual Table of Contents FN -2TXI Model Double Conversion On-line UPS Block Diagram FN SeriesTM Parallelable and N+1 Redundant UPS FeaturesStorage and Transportation InstallationFN Rackmount Overview Introduction Manual OverviewInput & Power Factor Correction DC/DC ConverterDC/AC Inverter Automatic Bypass Transfers Battery PacksInternal Battery Charger Static Bypass FunctionSystem unit received Unpacking the UPS and Battery BankFN Rackmount UPS Module FNBRM-1S7 Battery Module FNITRM-2 Rackmount Output Transformer ModuleFloor Loading Requirements PRE-INSTALLATION DetailsUPS Input/Output Requirements UPS Input Power RequirementsFN Rackmount System Rear Panel Overview UPS Output Rating DetailsPage Page Page Control Panel Display & ControlsControl Button and LCD Locations Control Button OperationLED Display Modes Status and Error Code Descriptions LCD Display OverviewLCD Icon Descriptions Page Operation How to start up the UPS with utility power presentPage How to completely shutdown the UPS How to display readings Page How to Display Programmed Settings Page Fixed or constant frequency How to Change the Programmed Settings Page Page Shows the UPS unit address. If Page UPS & PC Computer DB-9 pin designations are as follows CommunicationsModels Advanced Communications Option Cards AvailableOptional Remote Emergency Power Off Repo UPS Side RS-232C Interface Computer SideOptional Communications Interface Board Details UA88382 USB Interface Option Card UA88383 Dry Contact Interface Option CardUsha SNMP/HTTP Agent Option Card UPS and Battery Care MaintenanceParallel Mode Operation Recycling the Used Battery Packs EnvironmentalFCC Considerations Requesting Technical Information or Support Technical SupportFalcon ELECTRIC, INC NEW Product Limited WarrantyFN SeriesTM UPS Plus 3kVA 12kVA FN SeriesTM UPS Plus 4kVA 16kVA FN SeriesTM UPS Plus 5kVA 20kVA FN SeriesTM UPS Plus 6kVA 24kVA